Danfoss 100 FLOW Error 12.3.93: Fault Code 45, ID 441 - Device Added (Different Type)

Danfoss 100 FLOW · taken from the manufacturer’s manual, pages cited

Fault code12.3.93

A new power unit of a different type was installed, and no parameters are available in the settings. The manual's first action is: “Reset the fault. The drive reboots after you reset the fault.”

Model: Danfoss 100 FLOW
Display shows: Fault Code 45, ID 441 - Device Added (Different Type) (12.3.93)
Type: Fault code
Source: Manual p. 308

Meaning
Common causes
What to do
Still not solved
Source

What 12.3.93 means

Fault Code 45, ID 441 - Device Added (Different Type) p. 308

Common causes

There is a new power unit of a different type. Parameters are not available in the settings. p. 308

What to do

Reset the fault. The drive reboots after you reset the fault. p. 308
Set the power unit parameters again. p. 308

If 12.3.93 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Danfoss service.

Open the manual at page 308 All 100 FLOW error codes Manual details & download

This page summarises what the manufacturer’s manual says about 12.3.93; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Danfoss. Found a mistake? Report an error.