Canon NP7161/NP7160 Error E800

Copier · taken from the manufacturer’s manual, pages cited

Error codeE800

The power supply PCB or DC controller PCB is malfunctioning, resulting in general system failure. The manual's first action is: “Turn off and then on the power switch. Is the problem corrected?”

Model
Canon NP7161/NP7160
Display shows
E800
Type
Error code
Source
Manual p. 281

What E800 means

Malfunction p. 281

Common causes

  • Malfunction p. 281
  • Power supply PCB p. 281
  • DC controller PCB p. 281
  • The auto power-off circuit has an open circuit. p. 281
  • The DC controller PCB is faulty. p. 281

What to do

  1. Turn off and then on the power switch. Is the problem corrected? p. 281
  2. Replace the power supply PCB. Is the problem corrected? p. 281
  3. Check the wiring and continuity from the DC controller PCB to the control panel PCB; if normal, replace the DC controller PCB. p. 281
  4. An open circuit is detected for 5 V or 24 V at power-on. p. 281

If E800 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canon service.

Open the manual at page 281 All NP7161/NP7160 error codes Manual details & download

This page summarises what the manufacturer’s manual says about E800; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canon. Found a mistake? Report an error.