Canon NP7161/NP7160 Error E717

Copier · taken from the manufacturer’s manual, pages cited

Error codeE717

A connector or DC controller PCB is faulty, causing an error that may resolve with a simple power cycle. The manual's first action is: “Turn off and then on the power switch. Is the problem corrected?”

Model
Canon NP7161/NP7160
Display shows
E717
Type
Error code
Source
Manual p. 280

What E717 means

Malfunction p. 280

Common causes

  • Malfunction p. 280
  • Connector p. 280
  • DC controller PCB p. 280
  • Remote Diagnostic Device II p. 280
  • The DC controller PCB is faulty. p. 280
  • The Remote Diagnostic Device II PCB is faulty. p. 280

What to do

  1. Turn off and then on the power switch. Is the problem corrected? p. 280
  2. Is the connector (J722) used between the Remote Diagnostic Device II and the copier connected securely? p. 280
  3. Replace the DC controller PCB. Is the problem corrected? p. 280
  4. See the Service Manual of the Remote Diagnostic Device II. p. 280
  5. A condition in which a response from the Remote Diagnostic Device II cannot be received occurred three times continuously. p. 280
  6. The Remote diagnostic Device II communicates an interruption of count pulses. p. 280

If E717 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact Canon service.

Open the manual at page 280 All NP7161/NP7160 error codes Manual details & download

This page summarises what the manufacturer’s manual says about E717; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with Canon. Found a mistake? Report an error.