ABB ACS550-01 / ACS550-U1 Error 2010: MOTOR TEMP

ACS550-01/U1 drive · taken from the manufacturer’s manual, pages cited

Alarm code2010

Motor is hot, based on either the drive's estimate or on temperature feedback. This alarm warns that a MOT OVERTEMP fault trip may be near. The manual's first action is: “Check: • Check for overloaded motor. • Adjust the parameters used for the estimate (3005...3009). • Check the temperature sensors and Group 35: MOTOR TEMP MEAS.”

Model
ABB ACS550-01 / ACS550-U1
Display shows
MOTOR TEMP (2010)
Type
Alarm code
Source
Manual p. 268

What 2010 means

MOTOR TEMP p. 268

Common causes

  • Motor is hot, based on either the drive's estimate or on temperature feedback. This alarm warns that a MOT OVERTEMP fault trip may be near. p. 268

What to do

  1. Check: • Check for overloaded motor. • Adjust the parameters used for the estimate (3005...3009). • Check the temperature sensors and Group 35: MOTOR TEMP MEAS. p. 268

Before you service the product, read the safety instructions in the manual p. 6.

If 2010 is still not resolved

  • contact your local ABB representative for replacement p. 6
    “Never attempt to repair a malfunctioning drive; contact your local ABB representative for replacement.”
  • For more technical information, contact your local ABB representative. p. 7
    “For more technical information, contact your local ABB representative.”
Open the manual at page 268 All ACS550-01 / ACS550-U1 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 2010; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with ABB. Found a mistake? Report an error.