ABB ACS550-01 / ACS550-U1 Error 2009: DEVICE OVERTEMP

ACS550-01/U1 drive · taken from the manufacturer’s manual, pages cited

Alarm code2009

Drive heatsink is hot. This alarm warns that a DEVICE OVERTEMP fault may be near. The manual's first action is: “Check for and correct: • Fan failure. • Obstructions in the air flow. • Dirt or dust coating on the heat sink. • Excessive ambient temperature. • Excessive motor load.”

Model
ABB ACS550-01 / ACS550-U1
Display shows
DEVICE OVERTEMP (2009)
Type
Alarm code
Source
Manual p. 268

What 2009 means

DEVICE OVERTEMP p. 268

Common causes

  • Drive heatsink is hot. This alarm warns that a DEVICE OVERTEMP fault may be near. p. 268

What to do

  1. Check for and correct: • Fan failure. • Obstructions in the air flow. • Dirt or dust coating on the heat sink. • Excessive ambient temperature. • Excessive motor load. p. 268

Before you service the product, read the safety instructions in the manual p. 6.

If 2009 is still not resolved

  • contact your local ABB representative for replacement p. 6
    “Never attempt to repair a malfunctioning drive; contact your local ABB representative for replacement.”
  • For more technical information, contact your local ABB representative. p. 7
    “For more technical information, contact your local ABB representative.”
Open the manual at page 268 All ACS550-01 / ACS550-U1 error codes Manual details & download

This page summarises what the manufacturer’s manual says about 2009; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with ABB. Found a mistake? Report an error.