Industrial

EL5285 is a high-speed comparator from Intersil. It features 4ns typical propagation delay, 5V to 12V power supply voltage range, 2.7V to 5V output voltage range, and can be directly connected to CMOS and TTL logic circuits.

This document provides an overview and safety instructions for NetVista products.

1 ® FN7177.1 EL5144, EL5146, EL5244, EL5246, EL5444 100MHz single-supply rail-to-rail amplifiers

This document is a user guide for IBM products, covering topics such as safety instructions, computer setup, software recovery, troubleshooting, and IBM support.

EL4543 is a high bandwidth triple differential amplifier with integrated encoding of video sync signals

This is a user manual for an IBM computer. It mainly introduces the safety, installation and maintenance of the computer.

The E48SH series is Delta's latest 80W single output isolated DC/DC module, which adopts a high-efficiency architecture, wide input voltage range, large output current, and can be applied to various load applications, such as industrial control, power conversion, switch power supply, LED drive, etc.

This document describes the features and characteristics of the digital transistors (built-in resistors) DTC144EE / DTC144EUA / DTC144ECA / DTC144EKA / DTC144ESA from Jiangsu Changjiang Electronics Technology Co., Ltd. They have built-in bias resistors that enable the configuration of an inverter circuit without connecting external input resistors. The bias resistors consist of thin-film resistors with complete isolation to allow negative biasing of the input. They also have the advantage of almost completely eliminating parasitic effects. Only the on/off conditions need to be set for operation, making device design easy.

This document describes the characteristics of the 46 Unit Type Power Supply DSR30 model, including UL CSA certification, nominal output voltage, maximum output current, maximum output power, input voltage range, output voltage range, line regulation, load regulation, cooling method, operating ambient temperature, withstand voltage, and vibration.

The DS90CF384A/DS90CF364A is a +3.3V LVDS Receiver that converts 24-bit or 18-bit LVDS data streams (up to 1.8 Gbps throughput or 227 Megabytes/sec bandwidth) back into parallel 28-bit or 21-bit CMOS/TTL data (24-bit or 18-bit RGB and 4-bit or 3-bit Hsync, Vsync, DE and CNTL).

This product is a four-way T1 DS1/ISDN-PRI/J1 framing transceiver with independent transmit and receive functionality and can be configured for FDL or DS0 operation.

The DS1673 is an integrated circuit that incorporates many of the functions necessary for low-power portable products into a single chip. The device provides a real-time clock (RTC), NV RAM controller, microprocessor monitor, and a 3-channel, 8-bit analog-to-digital converter (ADC). Communication with the DS1673 is established through a simple 3-wire interface. The RTC provides seconds, minutes, hours, day, date, month, and year information with leap year compensation. The RTC also provides an alarm interrupt. This interrupt works when the DS1673 is powered by the system power supply or when in battery-backup operation, so the alarm can be used to wake up a system that is powered down. Automatic backup and write protection of an external SRAM is provided through the VCCO, CEOL, and CEOH pins. The backup energy source used to power the RTC is also used to retain RAM data in the absence of VCC through the VCCO pin. The chip- enable outputs to RAM (CEOL and CEOH) are controlled during power transients to prevent data corruption.