Industrial

This application note describes the use of an Agilent 6460 triple quadrupole LC/MS equipped with Agilent Jet Stream technology and direct aqueous injection for the analysis of a suite of acidic herbicides in several water matrices, thereby negating the need for solid phase extraction. Standard deviations in the range of 2.5% to 6.6% for analyte precision and recoveries of between 91.5% and 105.1% were observed over 11 batches of samples. Limits of detection were less than 10 ng/L (10 ppt) for all the compounds in the suite thus meeting current industry standards.

This application note successfully demonstrates the selective retention and resolution of low molecular weight sulfur containing species on an Agilent J&W GS-OxyPLOT column. The selective retention for sulfur species enables enough of a retention shift away from hydrocarbon matrices such as base gasoline and n-butane to demonstrate the feasibility of effective quantification of sulfur species in process streams. Using an Agilent J&W GS-OxyPLOT column it is possible to shift the retention of sulfur containing analytes away from a hydrocarbon matrix to achieve effective quantification in the low ppm range.

This document introduces an economical solution to test permanent gases and light hydrocarbons using the Agilent 7820A GC 3-valve system. The Agilent 7820A Gas Chromatograph equipped with three valves, a flame ionization detector (FID), and a thermal conductivity detector (TCD), is configured for analysis of permanent gases and light hydrocarbons. The TCD channel with packed columns is used to measure H2,CO2,O2, N2,CH4 and CO. A capillary column ( Al2O3 PLOT: 50 m × 0.53 mm) is used to measure all hydrocarbons (C1~C6) including CH4.

This document describes the features of the OPA177 precision bipolar op amp produced by Burr-Brown Corporation. The amplifier has low offset voltage and drift, high open-loop gain, low quiescent current, etc. It is suitable for precision instrumentation, data acquisition, test equipment, bridge amplifier, thermocouple amplifier, etc.

This document introduces a method for routine detection and quantification of biomarkers in petroleum using the Agilent 7890A/7000A Series Triple Quadrupole GC/MS with backflushing using a Pressure Controlled Tee configuration. In a single run, diverse biomarkers from several transitions can be detected, confirmed, and quantified at levels as low as 2 ppm, with RSDs well below 5%. This method is suitable for “fingerprinting” of petroleum samples and the deconvolution of oil mixtures in complex, multisource petroleum systems.

This document describes a method for analyzing trace hydrocarbon impurities in benzene using the Agilent 7820A gas chromatograph. The method is simple to use and can be used to analyze benzene and other aromatic solvents for impurities.

accurately measure particle sizes of polymers, applications in coatings, paints, adhesives, drug delivery systems and medical diagnostics

The OPA1632 is a fully-differential amplifier designed for driving high-performance audio analog-to-digital converters (ADCs). It provides the highest audio quality, with very low noise and output drive characteristics optimized for this application. The OPA1632's excellent gain bandwidth of 180MHz and very fast slew rate of 50V/µs produce exceptionally low distortion. Very low input noise of 1.3nV/√Hz further ensures maximum signal-to-noise ratio and dynamic range. The flexibility of the fully differential architecture allows for easy implementation of a single-ended to fully-differential output conversion. Differential output reduces even-order harmonics and minimizes common-mode noise interference. The OPA1632 provides excellent performance when used to drive high-performance audio ADCs such as the PCM1804. A shutdown feature also enhances the flexibility of this amplifier. The OPA1632 is available in an SO-8 package and a thermally-enhanced MSOP-8 PowerPAD package.

The document is about the analysis method of electroless plating bath, using capillary electrophoresis technology, can detect metal ions and inorganic anions

The document describes the use of Agilent's dual plasma sulfur chemiluminescence detector (DP SCD) and an online dilutor for the analysis of sulfur compounds. This method achieves detection limits of sulfur compounds at the ppb level. The long-term and short-term stability of DP SCD shows that its performance is stable, and no hydrocarbon interference was found during the analysis of natural gas samples.

The stationary phase of a GS-OxyPLOT column is a proprietary, salt deactivated adsorbent. GS-OxyPLOT columns show unique selectivity to oxygenated hydrocarbons, excellent stability and reproducibility, long column lifetime, and a wide application range.

Agilent Technologies has published an application note on the use of automated backflush on its 7890A/5975A GC-MS system, with a specific example of monitoring biomarkers in crude oil.

The OPA1632 is a fully-differential amplifier designed for driving high-performance audio analog-to-digital converters (ADCs). It provides the highest audio quality, with very low noise and output drive characteristics optimized for this application. The OPA1632’s excellent gain bandwidth of 180MHz and very fast slew rate of 50V/µs produce exceptionally low distortion. Very low input noise of 1.3nV/√Hz further ensures maximum signal-to-noise ratio and dynamic range. The flexibility of the fully differential architecture allows for easy implementation of a single-ended to fully-differential output conversion. Differential output reduces even-order harmonics and minimizes common-mode noise interference. The OPA1632 provides excellent performance when used to drive high-performance audio ADCs such as the PCM1804. A shutdown feature also enhances the flexibility of this amplifier. The OPA1632 is available in an SO-8 package and a thermally-enhanced MSOP-8 PowerPAD package.

This document introduces the structure and use of Agilent 7890A high pressure injector. It is a high pressure liquid sample injector for gas chromatography analysis, which can accurately and quickly analyze high volatile liquid samples.