Industrial

The document is a technical note on using Analog Devices' DSP components and development tools. It provides information on correctly setting mode pins in a design and offers general guidelines.

This document describes how to use the synchronous serial ports on the ADI DSPs to simulate RS-232 UART

This Engineering Note demonstrates how to interface a 5v FLASH memory to an ADSP- 218x DSP. The supplied code shows you how to program, erase, and retrieve device ID

This EE-Note will give an explanation of how long an idma access will take under varying conditions

The IOM-2 bus is a synchronous full duplex communication link for interconnecting telecommunications ICs. It satisfies the requirements of ISDN and analog applications and has been defined by four major European telephone equipment manufacturers. This document provides notes on using Analog Devices' DSP, audio, and video components with the ADSP-21xx interface to the IOM-2 bus.

This document introduces C language programming on the ADSP-21xx series DSP, focusing on the programming method of the timer.

This document provides insight into interfacing the AD1847 SoundPort Codec to an ADSP-2181 using a single index register for transmitting and receiving data via SPORT autobuffering. It includes initialization and codec setup instructions, as well as an example talkthru program using the AD1847's 1 wire mode.

This document is an engineer's note, which mainly introduces how to use Analog Devices' DSP, audio, and video components.

This document provides various strategies to increase the efficiency and usefulness of standard boot memory in 21xx systems.

This document is about choosing and using FFTs for ADSP- 21xx

describes the precautions for using serial ports in ADSP-21xx, including the startup timing, frame synchronization, data bit number and other issues to note when using serial ports

This document provides technical notes on using Analog Devices' DSP components and development tools, including the two major configuration modes of the ADSP-218x DSPs: full memory mode and host memory mode.

The purpose of this note is to describe how to hook up video devices like a CIF Single–Chip Digital Camera to the external bus of the ADSP-BF535 Blackfin® Processor. Because of its architecture and video processing capabilities, Blackfin Processors will interface with video devices.

The AD1953 and AD1836 can be combined to implement a 4-in/9-out analog system with DSP. This system can be used in automotive applications.