Industrial

STMicroelectronics AN2995 Demonstration Board User Guidelines for Single Operational Amplifiers provides a brief description of the demonstration board, a layout of the top and bottom layers, and some examples of typical configurations that can be tested with the board.

This application note provides a method to make an analog front-end plethysmograph based on the TS507. A plethysmograph is an instrument for measuring changes in volume within an organ or whole body, usually resulting from fluctuations in the amount of blood or air it contains. In this context, we refer in particular to the fluctuations in the quantity of blood in blood vessels.

The TSC101 is a high-side current sense amplifier that measures a very small voltage drop on a high-side shunt resistor and amplifies the difference into a ground-referenced output voltage.

TSH173 is a single supply triple video buffer featuring an internal gain of 6dB and an internal low pass filter of 8.2MHz cut-off frequency for each channel to fit with Standard Definition requirements for video line interfaces. This application note describes the TSH173 evaluation board, designed to help you evaluate the TSH173 triple video buffer.

This application note describes the most common operational amplifier stability compensation methods for capacitive loading applied to TS507.

TS97x is a low noise audio operational amplifier, which is used as a pre-amplifier for electret condenser microphones, with low distortion and high signal to noise ratio

The TS925 is an input/output rail to rail quad BiCMOS operational amplifier. It is able to operate with low supply voltages (2.7V) and to drive low output loads such as 32Ω. This technical note highlights many of the advantages of the device in a global audio application.

This document introduces an ADSL line interface driver based on TS613, which can be powered by a single supply and has passive or active impedance matching.

This document deals with the effects of SET (single event transient) on the output of the RHFL4913A low-drop linear regulator and introduces some solutions for coping with these effects.

This is the Jandy valve plumbing schematic

This manual contains important information about the installation, operation and safe use of this product.

This manual describes the installation and operation of the Jandy® AquaPure™ Electronic Chlorine Generator APURE700 and APURE1400, including safety information, system description, installation instructions, pool water preparation, etc.

This document is the installation and operation manual for HHPlus Series Pumps (Models PHP & PHPU). The pump must be installed and serviced by a professional service technician qualified in pool/spa installation. The procedures in this manual must be followed exactly to avoid dangerous electrical hazards. Improper installation and operation can cause high voltages to run through the electrical system, potentially resulting in death, serious injury, or property damage. This manual contains important information about the installation, operation, and safe use of the product, which should be given to the owner/operator of the equipment. It covers pump preparation and location, piping design and installation, electrical verification and installation, start-up, use and maintenance, troubleshooting, and specialty service such as removing blocked impeller.

This manual contains important information about the installation, operation and safe use of this product.