STMicroelectronics Manuals

STP80NF55-08/-1 STB80NF55-08 is a low-on-resistance N-channel power MOSFET with a maximum voltage of 55V and a typical on-resistance of 0.0065 ohms. It can be used in a variety of circuits, such as solenoid and relay drivers, audio amplifiers, DC-DC converters, and automotive environments.

The M74HC573 is a high speed CMOS Octal latch with 3-state outputs fabricated with silicon gate C2MOS technology. This 8-Bit D-Type latches is controlled by a latch enable input (LE) and output enable input (OE). While the LE input is held at a high level, the Q outputs will follow the data input precisely. When LE is taken low, the Q outputs will be latched precisely at the logic level of D input data. While the OE input is at low level, the eight outputs will be in a normal logic state (high or low logic level) and while is at high level the outputs will be in a high impedance state. The 3-State output configuration and the wide choice of outline make bus organized system simple. All inputs are equipped with protection circuits against static discharge and transient excess voltage.

This document introduces the main features of the BTA12, BTB12 and T12 series triacs, including application scenarios, package types, pin definitions, and specifications.

STPS15L60CB is a 2A power Schottky rectifier suited for Switch Mode Power Supply and high frequency DC to DC converters. Packaged in DPAK, this device is intended for use low voltage, high frequency inverters, free-wheeling and polarity protection applications.

This document describes the features and characteristics of the M74HC86 high-speed CMOS quad exclusive OR gate, including high speed, low power dissipation, high noise immunity, symmetrical output impedance, balanced propagation delays, and wide operating voltage range.

The BTA24, BTB24, BTA25, BTA26 and T25 series Snuberrless™ and Standard 25 A Triacs are products of STMicroelectronics. They are suitable for general purpose AC switching and can be used in applications such as static relays, heating regulation, induction motor starting circuits, and phase control operation in light dimmers, motor speed controllers. The snubberless versions (BTA/BTB.W and T25 series) are specially recommended for use on inductive loads, thanks to their high commutation performances.

STPS2045C is a double center tap Schottky rectifier from ST. It is suitable for SwitchMode Power Supply and high frequency DC to DC converters. Packaged either in TO-220AB, TO-220FPAB, I2PAK, or D2PAK, this device is especially intended for use in low voltage, high frequency inverters, free wheeling and polarity protection applications.

LCP02-150B1 is an integrated circuit for protecting ringing SLICs, widely used in SLICs with dual battery supplies, negative battery supply configuration, and negative and positive battery supply configuration.

ULN2064B - ULN2066B ULN2074B - ULN2076B ULN2068B - ULN2070B are Schmidt circuits with an output current of 1.5 A, a minimum working voltage of 50 V, a maximum working voltage of 35 V, integrated suppression diodes, and are compatible with 5 V logic circuits and 6-15 V CMOS and PMOS circuits.

This document describes the features and characteristics of the TL072, TL072A, and TL072B low noise JFET dual operational amplifiers, including wide common-mode and differential voltage range, low input bias and offset current, low noise, output short-circuit protection, high input impedance JFET input stage, low harmonic distortion, etc.

M74HC4020 is a high-speed CMOS 14-stage binary counter with features such as high speed, low power dissipation, high noise immunity, symmetrical output impedance, balanced propagation delays, and wide operating voltage range.

The document provides information about the main product characteristics of the STTH12R06 Turbo 2 ultrafast high voltage rectifier, including rated current, reverse voltage, forward voltage, reverse recovery current, etc.

TPI8011N/TPI12011N is a bidirectional triple crowbar protection device produced by STMicroelectronics, which can be used for ISDN interface and high speed data telecom line protection.

The STP35NF10 is a N-channel MOSFET from STMicroelectronics with a rated voltage of 100V, a typical on-resistance of 0.030 ohms and a maximum current of 40A. The device features low input capacitance and low gate charge, making it suitable for high-efficiency DC-DC converters, UPS and motor control applications.