The UA748 is a general purpose operational amplifier with features such as low offset and temperature drift, large common-mode and differential voltage ranges, low power consumption, and short-circuit protection. It can be used as a comparator and amplifier.
The TS912 is a single/dual supply operation rail-to-rail CMOS dual operational amplifier with extremely low input bias current, low input offset voltage, low supply current and latch-up immunity
This document describes the features and characteristics of the precision low power CMOS quad operational amplifiers TS27M4C, TS27M4I, and TS27M4M, released in September 2008 Rev 2.
TS27M2, TS27M2A, TS27M2B Low-power CMOS dual operational amplifiers feature a wide supply voltage range (3 to 16 V), ultra-low consumption (150 µA/op), output voltage swing to ground, excellent phase margin on capacitive load, gain bandwidth product of 1 MHz typical, and Vio down to 2 mV max. (B version)
The TS27L4 series are low-cost, low-power quad operational amplifiers designed to operate with single or dual supplies. These operational amplifiers use the ST silicon gate CMOS process allowing an excellent consumption-speed ratio. These series are ideally suited for low consumption applications. Three power consumptions are available enabling the best consumption-speed ratio: ICC = 10 µA/amp: TS27L4 (very low power), ICC = 150 µA/amp: TS27M4 (low power), ICC = 1 mA/amp: TS274 (standard). These CMOS amplifiers offer very high input impedance and extremely low input currents. The major advantage versus JFET devices is the very low input current drift with temperature (see Figure 4).
The TS271 is a low cost, low power single operational amplifier designed to operate with single or dual supplies. It offers very high input impedance and extremely low input currents.
The TL084 is a high performance, high speed, low power JFET quad operational amplifier with a wide common-mode voltage range (up to VCC +), low input bias and offset current, output short-circuit protection, high input impedance JFET input stage, internal frequency compensation, latch up free operation and high slew rate: 16 V/µs (typical).
The TL082 is a dual operational amplifier from STMicroelectronics. It features high output bandwidth, low input bias current and low output voltage drift.
The TL081, TL081A, and TL081B are high-speed JFET input single operational amplifiers incorporating well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The devices feature high slew rates, low input bias and offset currents, and low offset voltage temperature coefficient.
The TL072, TL072A and TL072B are high speed JFET input dual operational amplifiers incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit.
This document provides information about a product in full production. The product is a low noise JFET quad operational amplifier with wide common-mode and differential voltage range, low input bias and offset current, low noise, low harmonic distortion, and other features.
The TL071 is a high-performance, low-noise, high-input-impedance single-voltage-output operational amplifier. This operational amplifier uses well-matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high gain bandwidth, low input bias current, low input offset voltage, and good frequency compensation characteristics and thermal stability.
The TL064 is a low-power JFET quad operational amplifier with features including low power consumption, wide common-mode and differential voltage ranges, low input bias and offset currents, output short-circuit protection, high input impedance, and internal frequency compensation.
