TEXAS Manuals

SN74276 is a series of logic circuits produced by Texas Instruments

This document introduces the features and characteristics of the HVD2x family transceivers, including voltage range, receiver equalization, unit load, bus I/O protection, receiver hysteresis and so on.

The SN54HC164 and SN74HC164 are 8-bit parallel output serial shift registers that feature AND-gated serial inputs and an asynchronous clear (CLR) input. Package options include plastic small-outline (D) and ceramic flat (W) packages, ceramic chip carriers (FK), and standard plastic (N) and ceramic (J) 300-mil DIPs.

The TLV278x series is a single supply operational amplifiers from TI, with a supply voltage range of 1.8V to 3.6V, Rail-to-Rail input and output capability, bandwidth of 8MHz, high slew rate of 4.8V/µs, input noise voltage of 9nV/√Hz at 10kHz, rated temperature range of 0°C to 70°C(commercial grade), -40°C to 125°C(industrial grade), package form of PDIP, SOIC, and the newer SOT-23(single), MSOP(dual), and TSSOP(quad).

This document is about the TL750M and TL751M series low-dropout voltage regulators, which have very low dropout voltage, low quiescent current, TTL and CMOS compatible enable, 60V load dump protection, overvoltage protection, internal thermal overload protection and internal overcurrent limiting circuitry

This document describes the features of the SLUS499A product, including a 3V to 13.5V operating voltage range, support for multiple topologies, programmable voltage controlled oscillator, open lamp protection, etc. It is suitable for notebook computers, portable electronic displays, and portable instruments.

This datasheet introduces the UCC27221 and UCC27222 synchronous buck drivers products. This product can be used in low output voltage high efficiency DC-DC converter designs. Using Predictive Gate Drive (PGD) control technology, it can reduce the conduction and reverse recovery losses of the synchronous rectifier MOSFETs.

The UC3827 family of controller devices provides an integrated control solution for cascaded buck and push-pull converters. These converters are known as current fed or voltage fed push-pull converters and are ideally suited for multiple output and/or high voltage output applications. In both current fed and voltage fed modes, the push-pull switches are driven at 50% nominal duty cycles and at one half the switching frequency of the buck stage. In the current fed mode, the two switches are driven with a specified over-lap period to prevent ringing and voltage stress on the devices.

The TPS786xx family is a low-dropout linear voltage regulator with high PSRR, ultralow noise, fast start-up, and excellent line and load transient response.

TLV225x, TLV225xA is a low-voltage operational amplifier launched by Texas Instruments. It has low noise, low input bias current, can be used in single-supply or split-supply applications, low power consumption, etc. It is very suitable for battery-powered applications.

The TLK1221 gigabit Ethernet transceiver is a high-speed full-duplex point-to-point data transmission device. Its features include: support for data rates from 0.6 to 1.3 Gbps; low power consumption, with typical power consumption of 250 mW at 1.25 Gbps; LVPECL-compatible differential I/O interface; single monolithic PLL design; support for 10-bit interface; receiver differential-input thresholds with a minimum of 200 mV; operating temperature range from -40°C to 85°C; IEEE 802.3 gigabit Ethernet compliant; designed in 0.25µm CMOS technology; no external filter capacitors required; comprehensive suite of built-in testability; 2.5V supply voltage for lowest-power operation; 3.3V tolerant on LVTTL inputs; hot plug protection; 40-pin 6mm × 6mm QFN PowerPAD™ package.

This document describes the features and characteristics of the high-performance IMPACT-X PAL circuits TIBPAL16L8-5C, TIBPAL16R4-5C, TIBPAL16R6-5C, TIBPAL16R8-5C TIBPAL16L8-7M, TIBPAL16R4-7M, TIBPAL16R6-7M, TIBPAL16R8-7M.

This data sheet provides detailed information about the SN54LVTH574 and SN74LVTH574 3.3-V ABT octal edge-triggered D-type flip-flops, including electrical specifications, package options, and applications information.

Introduces the characteristics of SN74LVT240A