Key facts
- Brand
- Edimax
- Model
- RE11S
- Category
- Wireless connection
- Documents
- 4
- Languages
- ES · ZH · EN
- Last added
- 2026-11-06
Start here
Edimax RE11S AC1200 Dual-Band Wi-Fi Extender Quick Installation Guide
This document is a Quick Installation Guide for the Edimax RE11S AC1200 Dual-Band Wi-Fi Extender. It provides instructions on adding the device to an existing network using the WPS button and details the installation of the master extender. The guide explains how to configure the device in three specific modes: Access Point, Wi-Fi Extender, and Wi-Fi Bridge. This manual is written in Spanish.
Read onlineEdimax RE11S specifications
| Wireless Standard | 2.4 GHz and/or 5 GHz |
|---|---|
| Model Number | RE11S |
| Power Output (Eco Mode) | 25% |
Source: Edimax RE11S AC1200 Dual-Band Wi-Fi Extender Quick Installation Guide
All Edimax RE11S documents by type
The shortest path to a working setup, usually only a few pages.
Day-to-day operation, settings and troubleshooting. Start here if the product is already set up.
Questions answered in these manuals
Where should I place the Wi-Fi extender for best results?
The best location is approximately halfway between your wireless access point/router and the dead zone.
From: Edimax RE11S AC1200 Dual-Band Wi-Fi Extender Quick Installation Guide
What is the RE11S used for?
It is an AC1200 Dual-Band Wi-Fi Extender.
From: Edimax RE11S AC1200 Dual-Band Wi-Fi Extender Quick Installation Guide
How can I change the Wi‑Fi signal strength on the RE11S?
Use the signal‑strength switch on the bottom of the RE11S to select Normal (100 % signal), Eco (50 % signal) or Off.
From: Edimax RE11S AC1200 Wi‑Fi Extender Quick Installation Guide
How do I reset the extender to factory default settings?
Press and hold the WPS button for at least 10 seconds and release when the green power LED is flashing.
What does a flashing green WPS LED indicate?
It indicates that WPS is in progress and waiting for another WPS device.
How do I reset the device to factory default settings?
Press and hold the WPS button for at least 10 seconds and release when the green power LED is flashing.