Key facts
Start here
DYTRA 3035C Charge Mode Accelerometer Negative Output Outline/Installation Drawing and Specifications
The DYTRA Model 3035C is a charge mode accelerometer whose output signal polarity is negative for acceleration toward the top. The document combines an outline/installation drawing with a specifications table for the sensor.
The drawing gives the .281 hex by .33 inch case, the 5-40 integral mounting stud and the radially mounted 5-44 coaxial connector. Mounting port preparation calls for a flat area of at least .250, flat to .001 TIR, with a #38 (.101) hole .150 deep minimum and a 5-40 UNC-2B thread .125 deep minimum. The specifications list a 2.5 gram weight, 300 series stainless steel housing, 2.5 pC/G nominal sensitivity, +500 G full-scale range and a -100 to +400 °F temperature range.
DYTRA 3035C specifications
| Weight | 2.5 grams |
|---|---|
| Size, hex x height | .281 (9/32) x .33 inches |
| Mounting provision | 5-40 integral stud |
| Connector | 5-44 coaxial, radially mounted |
| Housing and connector material | 300 series stainless steel |
| Sensitivity, nominal | 2.5 pC/G |
| Range, full scale | +500 G's |
| Frequency range, +5% | 0.5 to 10 kHz |
| Resonant frequency, nominal | 45 kHz |
| Transverse sensitivity, max | 5% |
| Maximum vibration/shock | 600/3000 G's peak |
| Temperature range | -100 to +400 °F |
| Seal | Hermetic, glass-to-metal and TIG welded |
| Capacitance, nominal | 630 pF |
| Output signal polarity for acceleration toward top | Negative |
| Case grounding | Case grounded to electrical power ground |
All DYTRA 3035C documents by type
Ratings, dimensions and ordering codes, for selection and design work.
Questions answered in these manuals
What is the weight of the Model 3035C accelerometer?
The specified weight is 2.5 grams.
What mounting provision does the Model 3035C use?
It has a 5-40 integral stud.
What is the weight of the 3035CG accelerometer?
The accelerometer weighs 2.3 grams.
From: Dytra 3035CG Charge Mode Accelerometer Outline/Installation Drawing
What mounting method is recommended for the device?
The device is designed for an adhesive mount.
From: Dytra 3035CG Charge Mode Accelerometer Outline/Installation Drawing