Walchem EHE Series Electronic Metering Pump Instruction Manual

This manual provides installation, operation, programming, maintenance, and troubleshooting instructions for Walchem EHE Series electronic metering pumps.


Walchem EHE Series Electronic Metering Pump Instruction Manual - cover page
Brand
Walchem
Category
Industrial Robot
Document type
User Manual
Language
English
Pages
36
File format
PDF
File size
3.6 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
5B7737B67FD8E50CF579D3AB6AA54FE1

About this manual

The Walchem EHE Series electronic metering pump consists of a pump unit, a drive unit, and a control unit. The drive unit is an electromagnetic solenoid that moves an armature shaft attached to a PTFE faced diaphragm. When energized, the diaphragm is forced into the pump head cavity to increase pressure and force liquid out through discharge check valves. When de-energized, a spring returns the armature, pulling the diaphragm out to create a vacuum that refills the pump head from the supply tank.

The manual covers the complete lifecycle of the pump, including safety precautions, unpacking, location selection, tubing installation, electrical connections, priming, adjustment, calibration, and control unit programming. It also details maintenance procedures such as diaphragm and valve replacement, along with an exploded view and parts guide for ordering spare parts. Troubleshooting guidance is provided for common operational issues.

What's inside

  • Safety and Caution Notes
  • Principle of Operation
  • Specifications
  • Dimensions
  • Installation
  • Operation
  • Maintenance
  • Troubleshooting
  • Service Policy
  • Parts Guide

Specifications

Maximum Strokes per Minute360
Turndown Ratio1800:1
Ambient Temperature Range32 to 122°F (0 to 50°C)
Liquid Temperature Range (PVC)32 to 104°F (0 to 40°C)

Frequently asked questions

What are the safety precautions for working on the pump?

Always wear protective clothing, eye protection, and gloves before working on or near the metering pump.

Can the pump be installed in areas with high temperatures?

No, the pump should not be installed where ambient temperatures exceed 122°F (50°C) or fall below 32°F (0°C).

Is the pump pre-primed before shipping?

Yes, pumps are pre-primed with water at the factory, but they must be drained and dried if the application is not compatible with water.

Download PDF (3.6 MB)

More Walchem Manuals


View all Walchem manuals →