VPN12AD02-FU Evaluation Board User Manual

User manual for the VPN12AD02-FU evaluation board covering constant current and constant voltage LED driver applications, specifications, programming, quick…


VPN12AD02-FU Evaluation Board User Manual - cover page
Category
LED Driver Controller
Document type
User Manual
Language
English
Pages
12
File format
PDF
File size
1.2 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
9A9902CA7077F40220C8F4E267D6E830

About this manual

This guide covers the VPN12AD02-FU evaluation board for LED driver applications, including a constant current mode (1.5 A, 350 kHz, 3 to 8 LEDs) and a constant voltage mode (12 V output).

It provides electrical specifications, input UVLO and output OVP programming, switching frequency and LED current setting, quick start procedures, the schematic and BOM, and the four-layer PCB layout.

What's inside

  • Electrical Specification
  • Input UVLO Setting
  • Output OVP Setting
  • Frequency Setting
  • LED Constant Current Setting
  • Evaluation Board Schematic
  • BOM List
  • Quick Start Guide
  • Constant Voltage Application
  • Printed Circuit Board Layout

Specifications

Switching Frequency350kHz
LED Current1.5A
Input UVLO Falling7V
Input UVLO Rising7.4V
Output Voltage (Constant Voltage)12V
Output OVP (Constant Voltage)15V

Frequently asked questions

How is the LED constant current programmed?

Set the LED current with an external resistor R26 using ILED = (VFBH-FBL)/R26; VFBH-FBL is typically 150mV.

How is frequency spread spectrum enabled or disabled?

Add R11 = 10 kohm to enable frequency spread spectrum; remove R11 to disable it.

What LED counts do jumper JR25 settings support?

With JR25 short, connect 3~4 LEDs; with JR25 open, connect 5~8 LEDs.

Download PDF (1.2 MB)

Also Manuals