This is the CCM AE3726 technical datasheet (技术说明书), a six-page Chinese document describing a 16-bit constant-current LED driver that operates from a 3.3 V supply. Output current is set by a single external resistor connected to the R-EXT pin, so all outputs sink the same current. The chip contains a 16-bit constant-current output stage, a 16-bit shift register, a 16-bit latch and a gate circuit, built in a Bi-CMOS process, and is intended for common-anode LEDs.
The datasheet gives the pin assignment and pin descriptions, functional block diagram, truth table and timing diagrams, followed by absolute maximum ratings, recommended operating conditions, electrical characteristics, switching characteristics and a typical cascaded application circuit. It also warns that the device has no overvoltage, overcurrent or overtemperature protection, that protection must be added in the control circuit, and that the IC should be placed as close as possible to the LED module. This manual is written in Chinese.
| Output channels and current capability | 16 channels, 90 mA per channel |
|---|---|
| Constant current range | 2 to 80 mA |
| Supply voltage | 3.3 V typical (recommended 3.0 to 3.6 V) |
| Maximum output voltage | 17 V |
| Continuous data transfer rate | 20 MHz (cascaded limit) |
| Operating temperature range | -40 to 85 °C |
| Package | SOP24 |
| Power dissipation | 0.83 W (not mounted) |
It runs from a 3.3 V supply; the recommended operating range is 3.0 V to 3.6 V, and the absolute maximum supply voltage is 6 V.
By an external resistor connected between the R-EXT pin and GND; this resistor sets the output current value.
It has 16 constant-current outputs, with a current capability of 90 mA per channel and a settable range of 2 to 80 mA.
No. The chip does not include overvoltage, overcurrent or overtemperature protection, so protection must be added in the control circuit if needed.