Vishay Siliconix evaluation board manual for the SiP32419EVB and SiP32429EVB load switches, covering board connections, protection settings, schematic…
This manual describes the Vishay Siliconix SiP32419EVB and SiP32429EVB evaluation board for evaluating the over-current protection and programmable soft-start functions of the load switch. It covers power input and output terminals, test points, input and output capacitors, the enable terminal, fault and power-good flags, current-limit setting, and soft power-up calculations.
The document also includes the evaluation board schematic, PCB layout layers, bill of materials, and lab experiment results for power-up and output-short conditions.
| Switch on-resistance | 56 mΩ |
|---|---|
| Operating voltage range | 6 V to 28 V |
| Evaluation board input voltage range | 6 V to 24 V |
| Over-current shutdown time | More than 7 ms |
| Over-temperature shutdown threshold | About 145 °C junction temperature |
| Over-temperature hysteresis | About 20 °C |
| Enable pin voltage rating | 6 V |
| Enable threshold voltage | 1.5 V |
| Disable threshold voltage | 0.4 V or lower |
| Input and output capacitor capacitance | 10 μF |
| Input and output capacitor voltage rating | 50 V |
| Soft-start charge current | 5 μA |
| Package | DFN10 3 mm x 3 mm |
| Measured current limit | 1.365 A |
| Calculated current limit | 1.5 A |
The evaluation board input voltage range is from 6 V to 24 V, while the devices themselves can operate normally up to 28 V.
The current limit is set with the RSET resistor, which is R5 on the board, using the current limit formula given in the manual.
If the over-current condition persists for more than 7 ms, the switch shuts off automatically and the FLG pin is pulled low.
The soft power-up time is set by the built-in ISS charge current, the CSS capacitor (C9 on the board), the current limit resistor, and the output resistor.