Documentation for the Trinamic TMCM-302 triple-axis stepper motor motion control module, covering features, connections, operation and specifications.
The Trinamic TMCM-302 is a triple-axis 2-phase stepper motor motion control module based on the TMC428 motion controller. It creates Step and Direction signals for external power driver modules and can also be used with external stepper motor drivers that have an SPI interface.
The module can be remote controlled through CAN, RS-232 or RS-485, and stand-alone operation is possible with TMCL programs stored in the on-board EEPROM. The documentation covers ordering information, main features, operational conditions, ramp profiles, module connections, setup and operational calculations.
| Stepper motors supported | Up to three 2-phase stepper motors |
|---|---|
| Motion controller | TMC428 |
| Host interfaces | CAN 2.0b, RS-232, RS-485 |
| EEPROM | 16 KByte |
| Flash memory | 32 KByte |
| Full-step frequency | Up to 300 kHz |
| Module size | 80 x 50 mm2 |
| Supply voltage | 4.75 to 5.25 VDC at 5 VDC |
| Module current | Approximately 300 mA |
| Input voltage range | 0 to 5 VDC or TTL level |
| CAN differential input voltage | -8 to +18 VDC |
| Output current | 50 mA (microcontroller ports), 35 mA (shift register outputs) |
| Ambient temperature | Up to 70 C |
It can drive and control up to three 2-phase stepper motors.
The module can be remote controlled via CAN, RS-232 or RS-485.
Full step frequencies are supported up to 300 kHz.
It is suitable for ambient temperatures up to 70 C.