This guide explains how to configure PROFIBUS communication between Siemens S7-300 PLC and SINAMICS G120 drives to control motor start/stop and speed.
This document serves as an operation guide for establishing PROFIBUS DP communication between a Siemens S7-300 PLC (specifically CPU 314C-2 PN/DP) and a SINAMICS G120 drive with CU250S-2 DP control unit. It details the hardware configuration, software setup using STEP7 V5.5 SP4, and parameter settings required for data exchange. This manual is written in Chinese.
| Software Version | STEP7 V5.5 SP4 |
|---|
The guide uses Standard Telegram 1 (Standard telegram 1,PZD-2/2) to control the drive's start, stop, and speed.
Speed is controlled by sending the Master Setpoint (NSOLL_A) as a signed integer, where 16384 corresponds to 100% of the reference speed set in parameter P2000.