Installation and operation notes for Siemens SINUMERIK 840D sl NCU software 1.4 with ShopMill HMI.
This document is installation and operation notes for Siemens SINUMERIK 840D sl NCU software 1.4 with ShopMill HMI. It lists the software components and describes installation with the NCU service system, upgrade from NCU-SW 1.3, upgrade using WinSCP, and new installation on a CF card.
It also gives general notes on license keys, backup order, hardware, alarms, and NCK-specific notes such as cycle loading and G643/G644 usage. This manual is written in German.
| NCU software version | 1.4 with ShopMill HMI |
|---|---|
| LinuxBase (NCU) | V01.60.05 |
| NCK software | V67.02.01 |
| PLC-BeSy | V20.70.31 |
| NCU service system | V1.50.07 or higher |
| USB stick capacity | 512 MB |
| Unsupported USB stick | SanDisk cruzer mini 1.0 GB |
The NCU service system V1.50.07 or higher on a USB stick is required.
User data in /user, /addon, /oem and the license key remain on the CF card.
A SanDisk cruzer mini 1.0 GB USB stick does not work.
A factory reset of the NCU and PLC is required using the SIM/NCK and PLC switches.