User manual for the Seagate ST-225 hard disk drive, covering installation, jumper settings, specifications, and operating conditions.
This document is the product manual for the Seagate ST-225 hard disk drive, which was designed for use with the Olivetti M24 computer system. It provides technical specifications, installation instructions, and configuration details for the drive.
The manual details the physical mounting requirements, including approved orientations and screw specifications. It also explains the interface configuration options, such as Daisy-Chain and Radial modes, and describes the jumper settings on the user configuration block for drive selection and recovery mode.
| Capacity | 21/26 MB |
|---|---|
| Heads | 4 |
| Seek time / track | 65.0/20.0 ms |
| Sector/track | 17 |
| Controller | MFM / ST412 |
| Precompensation | 300 |
| Cache/Buffer | KB |
| Landing Zone | 670 |
| Data transfer rate | 0.625 MB/S |
| Bytes/Sector | 512 |
| Recording method | MFM |
| Supply voltage | 5/12 V |
| Temperature (operating) | 10 45 C |
| Humidity (operating) | 8 80 % |
| Altitude (operating) | -0.305 3.048 km |
| Shock (seek) | 10 g |
| Rotation | 3600 RPM |
| Power (standby) | 33.0 W |
| Power (read/write) | 33.0 W |
| MTBF | 100000 h |
| Warranty | Month |
| Cylinders | 615 |
| Defects (ST225) | 21 |
| Track-to-Track (ST225) | 20 msec |
| Average Access Time (ST225) | 65 msec |
| Average Access Time (ST225) max | 150 msec |
| Latency (ST225) | 8.33 msec |
For optimum performance, precompensation is recommended for tracks 300 through 614.
Mounting vertically on either end is a prohibited orientation.
There will be no more than 21 defects total per drive.
A Daisy-Chain configuration allows connection of a maximum of two drives on a common control cable.