Ringspann RLK 110 Cone Clamping Element Installation and Operating Instructions

Installation and operating instructions for Ringspann RLK 110 cone clamping elements, including safety, mounting, and tightening torque specifications.


Ringspann RLK 110 Cone Clamping Element Installation and Operating Instructions - cover page
Brand
RINGSPANN
Category
Industrial Robot
Document type
User Manual
Language
English
Pages
5
File format
PDF
File size
152 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
23691CC77FC8612B9471F96C7BD61434

About this manual

This document provides step-by-step instructions for installing, operating, and maintaining the Ringspann RLK 110 cone clamping element. It includes safety warnings, mounting procedures, and tightening torque specifications. The element is designed for backlash-free fastening of hubs on shafts and transmits torque and/or axial forces via frictional connection. Proper use and material tolerances are critical for safe operation.

The manual also covers dismantling procedures, maintenance recommendations, and inspection guidelines for reusable elements. Safety precautions emphasize that only skilled personnel should install or repair the product, and power must be switched off before working on electrical components.

What's inside

  • Installation
  • Operating Instructions
  • Safety Notice
  • Mounting
  • Dismantling
  • Maintenance
  • Tightening Torque
  • Technical Requirements

Specifications

Tightening Torque MsVaries by size (e.g., 2.1 Nm for 6x14, 144.0 Nm for 110x140)
Shaft Toleranceh8
Hub Bore ToleranceH8
Surface Roughness Ra< 3.2 µm
Material E-Moduleabout 170 kN/mm²

Frequently asked questions

What is the purpose of the RLK 110 cone clamping element?

It is an internal clamping connection for backlash-free fastening of hubs on shafts, transmitting torque and/or axial forces via frictional connection.

What is the tightening torque for the RLK 110 clamping screws?

Tightening torque varies by size; for example, 2.1 Nm for 6x14 and 144.0 Nm for 110x140.

What materials are required for shafts and hubs?

Materials must have an E-module of about 170 kN/mm² and meet specified tolerances and surface roughness.

Download PDF (152 KB)

More RINGSPANN Manuals


View all RINGSPANN manuals →