OMRON CP1H Modbus RTU Connection Operation Manual

Guide to connecting the OMRON CP1H PLC with a CP1W-CIF11 module to Modbus RTU remote I/O, covering wiring, settings and program examples.


OMRON CP1H Modbus RTU Connection Operation Manual - cover page
Brand
Omron
Category
Automation control Equipment
Document type
User Manual
Language
Chinese
Pages
10
File format
PDF
File size
3.1 MB
Published
08 November, 2026
Updated
08 November, 2026
Model
CP1H
MD5 checksum
12E63A569A836C64C6DACC3176837105

About this manual

This manual explains how to link an OMRON CP1H controller to Modbus RTU remote I/O modules using the CP1W-CIF11 communication module and CX-Programmer software. It first lists the remote I/O module set: the GFMS-RM01S Modbus RTU master, the GFDI-RM01N 16-channel digital input module, the GFDO-RM01N 16-channel digital output module, the GFPS-0202 and GFPS-0303 power modules, and the 0170-0101 RJ45/RS-485 adapter module.

The document then covers the CP1W-CIF11 switch settings for terminating resistor, 2-wire/4-wire wiring and RS control, and the terminal wiring of RDA-/RDB+ to the adapter module. It describes serial port and Serial Gateway configuration in CX-Programmer, the communication register addresses, and a sample program that polls one GFDI-RM01N input and one GFDO-RM01N output. This manual is written in Chinese.

What's inside

  • Remote I/O module parts list
  • Product description
  • OMRON CP1H connection settings
  • CP1H hardware wiring
  • CP1W-CIF11 switch settings
  • CP1H communication settings
  • Communication command programming
  • Communication register read and write
  • Program example

Specifications

GFMS-RM01S master controllerMaster Modbus RTU, 1 port
GFDI-RM01N digital inputDigital input, 16 channels
GFDO-RM01N digital outputDigital output, 16 channels / 0.5 A
GFPS-0202 power module24 V / 48 W
GFPS-0303 power module5 V / 20 W
0170-0101 adapter module8-pin RJ45 female connector / RS-485 interface
First GFDI-RM01N register address1000 (HEX)
First GFDO-RM01N register address2000 (HEX)

Frequently asked questions

How do you connect an OMRON CP1H to Modbus RTU modules?

The CP1H is combined with the CP1W-CIF11 communication module, and the connection is configured with CX-Programmer software.

What do the CP1W-CIF11 switches set?

Switch 1 sets the terminating resistor, switches 2 and 3 set the wiring type (ON for 2-wire, OFF for 4-wire), and switches 5 and 6 enable RS control.

What is the register address of the first GFDI-RM01N?

The first GFDI-RM01N uses register address 1000 (HEX).

How is the serial port set up in CX-Programmer?

In CX-Programmer, open the serial port settings from the PLC menu, set the communication format and baud rate, and select Serial Gateway.

Download PDF (3.1 MB)

More Omron Manuals


View all Omron manuals →