Nordson Encore iControl 2 integrated control system manual covering installation, troubleshooting, repair, and replacement parts.
This is the Nordson customer product manual (document number 1603638-17) for the Encore iControl 2 Integrated Control System. It is organized into sections for safety, overview, system connections, troubleshooting, repair, parts, and drawings, and it describes the console and pedestal hardware, gun cards, iFlow digital flow modules, internal and external networks, and the operator interface.
The manual gives general specifications such as air pressure and electrical requirements, environmental limits, and the hazardous location rating of the pedestal, together with connection diagrams, error codes and alarm messages, gun card and iFlow module troubleshooting, and procedures for replacing the touch screen, CMOS battery, and gun control cards.
| Supply air pressure input | 6.2−7.6 bar (90−110 psi) |
|---|---|
| Supply air hose | 3/4-in. ID minimum |
| Maximum output per pump | 13.6 m3/hr (8 scfm) |
| Electrical input (unswitched, PC) | 100−230 Vac, 50/60 Hz, 1 ∅, 100 VA max. |
| Output to spray gun | ± 19V, ±1A (peak) |
| Operating temperature | +15° C to +40 ° C |
| Operating humidity | 5−95%, non-condensing |
| Hazardous location rating | Class II Division 2, Groups F & G, Zone 22 area (pedestal only) |
The input supply air pressure is 6.2−7.6 bar (90−110 psi), supplied through a hose of 3/4-in. ID minimum.
Only the iControl 2 Pedestal is certified for hazardous locations or zones; the main and auxiliary consoles must always be located outside the hazardous area.
The system operates from +15° C to +40° C at 5−95% relative humidity, non-condensing.
The unswitched PC input is 100−230 Vac, 50/60 Hz, single phase, 100 VA maximum; the switched input is rated 250 VA maximum.