Nordson Encore C0114 LT Manual Powder Spray System Operator Card

Operator card for the Nordson Encore C0114 LT manual powder spray system, covering controller interface, electrostatic and powder flow settings, operation…


Nordson Encore C0114 LT Manual Powder Spray System Operator Card - cover page
Brand
Nordson
Category
Other
Document type
Quick Start Guide
Language
English
Pages
4
File format
PDF
File size
112 KB
Published
10 November, 2026
Updated
10 November, 2026
MD5 checksum
17EA7928EA8930D94F1ED04E99628277

About this manual

This operator card covers the Nordson Encore C0114 LT manual powder spray system, including the controller interface, configuration functions, electrostatic settings (Select Charge, Custom, Classic, and Encore LT PE modes), and powder flow settings (Smart Flow and Classic Flow modes). It also describes system operation, purge and fluidizing air behavior, and controller sleep/wake functions.

The card provides maintenance instructions for cleaning the spray gun nozzle, powder path, pump nozzle, and venturi throat, along with a troubleshooting table addressing common problems such as no powder spray, uneven patterns, low powder flow, poor transfer efficiency, and keypad issues.

What's inside

  • Controller Interface
  • Controller Configuration
  • Electrostatic Settings
  • Powder Flow Settings
  • System Operation
  • Maintenance
  • Troubleshooting

Specifications

Gun Type Setting0 = Encore
Fluidizing Setting0 = Hopper, 1 = Box, 3 = Disable
Electrostatic Control Setting0 = Custom, 1 = Classic, 2 = PE
Powder Flow Control Setting0 = Smart, 1 = Classic
Cable Length Setting0 = 6 meters, 1 = 12 meters, 2 = 18 meters
Vibratory Box Delay0−90 seconds (factory default 30)
STD kV Range0 or 25−100 kV
Re-Coat Select Charge Mode100 kV, 15 μA
Metallics Select Charge Mode50 kV, 50 μA
Deep Recesses Select Charge Mode100 kV, 60 μA
Minimum Input Air PressureGreater than 4.1 bar (60 psi)
Ground ResistanceLess than 1 mΩ
Controller Sleep TimeoutApproximately 15 minutes

Frequently asked questions

How do I wake the controller from sleep mode?

Press the Enable/Disable button, pull the gun trigger, press the purge switch, or press a button on the controller interface. The system goes to sleep automatically after approximately 15 minutes of no activity.

How do I enter controller configuration mode?

During power up or wake up from disable, press and hold the + and − buttons on the kV/μA panel for 1 second. The kV/μA panel displays F − 1 for function 1 when configuration mode is active.

What are the Select Charge mode electrostatic setpoints?

Re-Coat is 100 kV and 15 μA, Metallics is 50 kV and 50 μA, and Deep Recesses is 100 kV and 60 μA.

What should I do if the gun is not spraying powder and the Trigger LED is blinking?

Release the spray trigger, press the Disable/Enable button to put the controller to sleep, then press it again to wake it up. Check the cable and trigger switch.

Download PDF (112 KB)

More Nordson Manuals


View all Nordson manuals →