Kohler installation guide for K-302, K-303, and K-6934 two-valve and three-valve wall-mount bath/shower fittings, covering rough-in and installation steps.
This Kohler installation guide covers two-valve and three-valve wall-mount bath/shower fittings, including product numbers K-302, K-303, and K-6934. It explains how to prepare for installation, shut off the water supply, and inspect components before beginning work.
The document provides rough-in dimensions, bath and shower installation steps, ceiling supply instructions, and separate procedures for shower-only and bath-only installations. Required tools and materials include pipe wrenches, solder, thread sealant, plumbers putty, and assorted screwdrivers.
| Rough-in supply yoke distance | 2-1/4 in (5.7 cm) minimum to 3 in (7.6 cm) maximum |
|---|---|
| Supply tubing size | 1/2 in hot and cold |
| Typical shower head height | 72 in (182.9 cm) to floor |
| Typical bath spout height | 4 in (10.2 cm) |
A pipe wrench, adjustable wrench, strap wrench, hacksaw or tubing cutter, propane torch, solder, hex wrench, thread sealant, plumbers putty, and assorted screwdrivers are needed.
Rough-in the supply yoke 2-1/4 inches (5.7 cm) minimum to 3 inches (7.6 cm) maximum from the centerline of the yoke to the outside of the finished wall.
Yes, use a 3/8 inch hex wrench to remove the aspirator from the yoke and discard it.