Hi-Force PB Hydraulic Pipe Bender Operation Manual

Hi-Force PB hydraulic pipe bender operation manual (TDS1379) covering specifications, safety, bending steps, maintenance and troubleshooting.


Hi-Force PB Hydraulic Pipe Bender Operation Manual - cover page
Brand
Hi-Force
Category
Other
Document type
User Manual
Language
Chinese
Pages
7
File format
PDF
File size
566 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
547B3BEC6FED4746BC2E6E862EA46CE1

About this manual

This is the Chinese-language operation manual (document TDS1379) for the Hi-Force PB hydraulic pipe bender, a 700 bar / 10,000 psi tool with 10-ton maximum output, 250 mm piston stroke and a maximum bending angle of 90°. It covers receiving inspection, safety warnings, product specifications and features, pre-operation and post-operation checks, a step-by-step bending procedure, maintenance and a troubleshooting table.

Maintenance guidance calls for genuine Hi-Force hydraulic oil, full retraction of the cylinder after use, dust caps on the quick couplers, cleaning of the tool head and proper storage, with a recommended working temperature of -10°C to 40°C. Servicing should be carried out at an authorized Hi-Force repair center using genuine Hi-Force parts, and the manual refers users to the Hi-Force catalog or www.hi-force.com for further safety information. This manual is written in Chinese.

What's inside

  • Receiving Inspection
  • Safety
  • Product Specifications
  • Product Features
  • Pre-operation Checks
  • Operating Procedure
  • Maintenance
  • Troubleshooting

Specifications

Width755 mm
Weight18.6 kg
Maximum working pressure700 bar / 10,000 psi
Oil requirement0.4 L
Maximum output capacity10 tons
Piston stroke250 mm
Maximum bending angle90°
Bending capacity, thin steel conduit15 mm - 75 mm (5/8") - (3")
Bending capacity, thick steel conduit16 mm - 82 mm (1/2") - (3")
Bending capacity, gas pipe15 mm - 65 mm (1/2") - (2 1/2")
Recommended working temperature-10°C to 40°C

Frequently asked questions

What is the maximum working pressure of the Hi-Force PB pipe bender?

The maximum working pressure is 700 bar / 10,000 psi. Pumps connected to the tool must not exceed this rated pressure.

What hydraulic oil should be used with the tool?

Only genuine Hi-Force hydraulic oil should be used; other fluids may void the tool's warranty.

What is the maximum bending angle?

The tool can bend up to 90°.

What should I check if the tool does not extend?

The troubleshooting table lists loose couplers, an open pump pressure release valve, too little oil in the pump, a pump fault or a release valve set too low, and excessive load or full stroke of the tool.

Download PDF (566 KB)

More Hi-Force Manuals


View all Hi-Force manuals →