Hanna HI 991300 portable pH/EC/TDS/temperature meter instruction manual covering specifications, pH and EC/TDS calibration, battery replacement and accessories.
This instruction manual covers the Hanna HI 991300 portable pH/EC/TDS/temperature meter. It lists the meter's specifications, including pH, EC, TDS and temperature ranges, resolution and accuracy, the HI 1288 probe, battery type and life, operating environment and dimensions.
The operational guide explains how to connect the probe, turn the meter on and check battery status, select pH, EC or TDS, freeze a reading and turn the meter off. Separate sections describe pH measurement and calibration with the 4.01/7.01/10.01 or 4.01/6.86/9.18 buffer sets, EC/TDS measurement with conversion factor and BETA settings, EC calibration in HI 7031 solution, changing the temperature unit, battery replacement, and the available calibration solutions and accessories.
| pH range | 0.00 to 14.00 pH |
|---|---|
| EC range | 0 to 3999 µS/cm |
| TDS range | 0 to 2000 ppm |
| Temperature range | 0.0 to 60.0°C / 32.0 to 140.0°F |
| pH resolution | 0.01 pH |
| pH accuracy | ±0.01 pH at 20°C/68°F |
| EC/TDS accuracy | ±2% F.S. |
| EC/TDS calibration | Automatic (25°C/77°F), 1 point at 1413 µS/cm, 1382 ppm (0.5 conv.) or 1500 ppm (0.7 conv.) |
| Conductivity to TDS conversion factor | 0.45 to 1.00 (CONV) |
| Probe | HI 1288 pH/EC/TDS/temp. probe (included) |
| Battery | 4 x 1.5V AAA with BEPS, 500 hours |
| Environment | 0 to 50°C (32 to 122°F); RH 100% |
| Dimensions | 143 x 80 x 38 mm (5.6 x 3.2 x 1.5 in.) |
| Compliance | CE directives EN 50081-1, EN 50082-1 and EN 61010-1 |
Press the SET/HOLD button while in normal measurement mode; the meter displays pH, EC or TDS, and the temperature stays on the bottom of the display.
The meter uses 4 x 1.5V AAA batteries with BEPS and gives about 500 hours of battery life.
The probe is immersed in HI 7031 calibration solution at 1413 µS/cm, and calibration is performed automatically.
Remove the 4 screws on the back of the meter, replace the 4 AAA batteries while watching their polarity, then refit the back with the gasket properly seated.