Hanna Auto Routing Framework Chip Automatic Wire Drawing System User Manual

About this manual

The Hanna Auto Routing system is a plugin for AutoCAD 2012 and later versions that automatically generates DIEs, pads, and wiring based on an Excel Netlist and a prepared framework template. The software requires the user to have AutoCAD installed and provides specific installation instructions for different AutoCAD versions. This manual is written in Chinese.

What's inside

• System Introduction
• Loading and Execution
• Activation Process
• Menu Loading
• Netlist Creation
• AutoCAD Framework Template Preparation
• Automatic Wire Drawing
• Rotating DIEs

Frequently asked questions

Which AutoCAD versions are supported by this system?

The software works as a plugin for AutoCAD 2012 and above.

What are the two main data requirements to complete automatic wire drawing?

You need an Excel format Netlist and a framework template created using Hanna commands.