Flexco Pro 600 and Pro 6000 Belt Fastener Operation Manual

Operation manual for Flexco Pro 600 and Pro 6000 belt fasteners, covering unpacking, belt-end preparation, fastener installation, control settings…


Flexco Pro 600 and Pro 6000 Belt Fastener Operation Manual - cover page
Brand
Flexco
Category
Other products
Document type
User Manual
Language
Chinese
Pages
28
File format
PDF
File size
1.3 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
9447C58CD99B1309953D9DFD4DC14C10

About this manual

This manual covers the Flexco Pro 600 and Pro 6000 belt fastener. It describes unpacking and setup, preparing conveyor belt ends, selecting and inserting fasteners, machine preparation, and fastening procedures, including continuous fastening for belts wider than the comb.

It also explains operation of the Siemens TD200 control, including preset modes, pressure, temperature, and hold-time settings, machine limits, and the heating mode available only on the Pro 6000. Additional sections cover cam adjustment, troubleshooting, recommended workbench setup, and a Pro 6000 spare parts list. This manual is written in Chinese.

What's inside

  • Unpacking and setting up the Pro series fastener
  • Preparing conveyor belt ends
  • Machine preparation
  • Determining the required number of fasteners
  • Inserting fasteners into the comb
  • Operation with Siemens TD200 control
  • Fastening procedure
  • Continuous fastening
  • Troubleshooting
  • Spare parts list (Pro 6000)

Specifications

Comb widths24" to 60"
Gauge pin thickness20-30% thinner than belt thickness
Preset modes F1, F5, F6, F775 bar, 1 s hold, 25 C
Preset mode F2300 bar, 5 s hold, 25 C
Preset mode F3400 bar, 5 s hold, 25 C
Preset mode F4500 bar, 5 s hold, 25 C
Minimum pressure60 bar
Maximum pressure550 bar
Maximum temperature200 C
Maximum hold time20 s
Re-press pressure difference25 bar
Recommended workbench width60" or 12" wider than widest belt
Pressure adjustment increment50 bar or less
Side plate adjustmentBack off 1-1/2 turns after snug
Heating modePro 6000 only
Comb 25 gauge pins1.5, 1.5 x 1.8, 1.5 x 2.0 mm
Comb 36 gauge pins1.5, 1.5 x 1.8, 1.5 x 2.0 mm
Comb 1 gauge pins1.8, 2.0, 2 x 2.5, 2 x 3 mm
Comb 2 gauge pins2.5, 3.5 x 3.0, 4.0 x 3.0 mm

Frequently asked questions

What should I do if the machine does not run?

Check that it is powered and switched on, verify the outlet, press the reset button, and replace the fuse in the electrical box.

How do I switch between Celsius and Fahrenheit and between bar and PSI?

Press F8.

Which model has the heating mode?

The heating mode is available only on the Pro 6000.

What is the recommended workbench width?

60 inches, or 12 inches wider than the widest belt.

Download PDF (1.3 MB)

More Flexco Manuals


View all Flexco manuals →