Express 112 TransTube Series Guitar Amplifier User Manual

User manual for the Express 112 TransTube Series guitar amplifier, covering controls, specifications, tone settings, and safety warnings.


Express 112 TransTube Series Guitar Amplifier User Manual - cover page
Category
amplifier
Document type
User Manual
Language
English
Pages
16
File format
PDF
File size
1.5 MB
Published
21 November, 2026
Updated
21 November, 2026
MD5 checksum
06F63EC625E715631F0D70567A3465A3

About this manual

This manual covers the Express 112 TransTube Series guitar amplifier. It describes front-panel inputs, volume, tone, gain, reverb, effects loop, T. Dynamics, and channel controls.

Specifications, tone settings, a block diagram, and multilingual safety warnings are included. The amplifier is rated at 65 W RMS into 8 ohms.

What's inside

  • Safety symbols and warnings
  • Front-panel inputs
  • Volume and channel controls
  • Equalization controls
  • Gain and Thrash switches
  • Effects send and return
  • T. Dynamics control
  • Specifications
  • Tone settings
  • Block diagram

Specifications

Rated power65 W RMS into 8 ohms
Power at clipping65 W RMS into 8 ohms
Frequency response+0, -3 dB, 60 Hz to 20 kHz, @ 50 W RMS into 8 ohms
Hum and noiseGreater than 78 dB below rated power
Power consumption200 W @ 50/60 Hz, 120 V AC (Domestic)
Effects Send load impedance1 K ohm or greater
Effects Send nominal output level-10 dBV, 0.3 V RMS
Preamp high gain input impedanceHigh 2, 1 M ohm
Preamp high gain nominal input level-14 dBV, 200 mV RMS
Preamp high gain minimum input level-24 dBV, 60 mV RMS
Preamp high gain maximum input level0 dBV, 1 VRMS
Preamp low gain input impedanceHigh Z, 44 K ohms
Preamp low gain nominal input level-8 dBV, 400 mV RMS
Preamp low gain minimum input level-18 dBV, 120 mV RMS
Preamp low gain maximum input level6 dBV, 2 VRMS
Effects Return impedanceHigh Z, 22 K ohms
Effects Return designed input level-10 dBV, 0.3 V RMS
System hum and noise68 dB below rated power
EqualizationSpecial low, mid, and high passive type EQ
Push Bright boost+6 dB @ 2 kHz
Push Thrash notch-20 dB notch @ 1 kHz in Lead channel
Push Gain functionIncreases Lead gain
External speaker minimum total impedance8 ohms
T. Dynamics power level adjustment10% to 100% power

Frequently asked questions

What is the minimum total impedance for an external speaker cabinet?

The minimum total impedance is 8 ohms.

What does the T. Dynamics control do?

It adjusts the amplifier power level from 10% to 100% power, and lower settings make the power compression simulation more pronounced.

What does the Thrash switch do?

It notches the mid range about 20 dB.

Which input is louder?

The High Gain input is 6 dB louder than the Low Gain input.

Download PDF (1.5 MB)

Also Manuals