ESTUN ER-Arc Support Arc Welding Software Package Installation Guide

Installation and debugging guide for the ESTUN ER-Arc Support arc welding software package, covering preparation, configuration, and update notes.


ESTUN ER-Arc Support Arc Welding Software Package Installation Guide - cover page
Brand
Estun
Category
Industrial Robot
Document type
Installation Guide
Language
Chinese
Pages
32
File format
PDF
File size
1.6 MB
Published
21 October, 2026
Updated
21 October, 2026
MD5 checksum
E028A3B86316A4501722B51691128753

About this manual

This document provides detailed instructions for the installation and debugging of the ESTUN ER-Arc Support arc welding software package. It is intended for engineers responsible for installing and configuring the software on ESTUN six-axis robots.

The guide covers three main areas: preparation steps including checking software files and hardware requirements (welders and robots), configuring the software project using KeStudio, and a list of software update notes. This manual is written in Chinese.

What's inside

  • Preparation
  • Check Software
  • Check Hardware
  • Check Version
  • Configure Project
  • Associate Variable Values
  • Add Library Files
  • Load Interface
  • Add Command and Comment Files
  • Update Notes

Frequently asked questions

What is the default unit for length measurements in this manual?

The default unit for length is millimeters (mm) unless otherwise specified.

Which specific robot model is required for this software package?

The software requires an ESTUN six-axis robot.

What version of the KEBA software is required for installation?

The required KEBA software version is 2.66.

Download PDF (1.6 MB)

More Estun Manuals


View all Estun manuals →