Endress+Hauser Promag 10 HART Electromagnetic Flowmeter User Manual

About this manual

This operating manual covers the Endress+Hauser Promag 10 HART electromagnetic flowmeter, a device for measuring the flow rate of conductive fluids in closed pipes. It includes safety instructions, identification details, installation steps, wiring diagrams, operating procedures, commissioning checks, maintenance guidelines, accessories, troubleshooting, and technical specifications.

The document is organized into sections such as Safety Instructions, Identification, Installation, Wiring, Operation, Commissioning, Maintenance, Accessories, Troubleshooting, Technical Data, and an Appendix, providing comprehensive guidance for trained personnel responsible for the device's setup and upkeep.

What's inside

• Safety Instructions
• Identification
• Installation
• Wiring
• Operation
• Commissioning
• Maintenance
• Accessories
• Troubleshooting
• Technical Data

Specifications

Frequently asked questions

What minimum fluid conductivity is required for measurement?

The flowmeter can measure liquids with a minimum conductivity of 50 µS/cm.

How should the transmitter be grounded during installation?

The transmitter must be grounded using the ground terminal inside the connection housing, keeping the stripped and twisted lengths of cable shield to the ground terminal as short as possible.

What are the recommended inlet and outlet run lengths?

The inlet run should be at least 5 × DN and the outlet run at least 2 × DN.

What safety standards does the device comply with?

It complies with EN 61010‑1, IEC/EN 61326, and NAMUR Recommendations NE 21 and NE 43.