DREHMO i-matic (DiM) electric actuator operation manual covering installation, operation, LEARN setup, menu structure, maintenance and troubleshooting.
This operation manual covers the DREHMO i-matic series electric actuators, including the on/off, stepping and modulating versions, for multi-turn, part-turn and linear actuator types. It contains installation instructions, operating instructions and maintenance instructions, and it applies to software version V1.06.0080. The documents supplied with the actuator are listed as this installation, commissioning and maintenance manual, the wiring diagrams, and additional manuals for the PROFIBUS and Modbus fieldbus interfaces.
The manual begins with safety and use notes, environmental conditions and personnel requirements, then gives design data and a table of technical data for the DiM, DiMR and DPiM models. Later sections describe the display and push buttons, the LEARN mode and its menu, the complete menu structure with parameter descriptions, the infrared interface, message and fault lists, operation, and maintenance including oil replacement, fuse replacement, insulation measurement, cleaning, spare parts and troubleshooting. This manual is written in Chinese.
| 允许环境温度 | -25 °C to +70 °C |
|---|---|
| 防护等级 | IP67 (IEC 529) standard; IP68 (5 m for 24 h) optional |
| 安装海拔高度 | below 2000 m |
| 振动 | 10–100 Hz, amplitude 2 g |
| 空气湿度 | max. 80 % / 31 °C |
| 继电器接点容量 | max. 230 V AC 5 A, 110 V DC 2 A (gold-plated contacts, resistive load) |
| 控制信号电缆截面 | 0.5 mm² to 2.5 mm² |
The instructions in the manual apply to software version V1.06.0080.
The actuators are designed for a temperature range from -25 °C to +70 °C.
The standard degree of protection is IP67 according to IEC 529; IP68 (immersed 5 m deep for 24 hours) is also available.
The actuator is designed for a maximum installation altitude of 2000 m.