Danfoss VLT AutomationDrive FC 302 12-Pulse Drive Operating Manual

Chinese operating manual for the Danfoss VLT AutomationDrive FC 302 12-pulse drive: installation, wiring, programming, specifications, warnings and alarms.


Danfoss VLT AutomationDrive FC 302 12-Pulse Drive Operating Manual - cover page
Brand
Danfoss
Category
inverter
Document type
User Manual
Language
Chinese
Pages
96
File format
PDF
File size
6.4 MB
Published
10 November, 2026
Updated
10 November, 2026
Model
FC 302
MD5 checksum
1877A906756C89244DA6080E0F1CFF65

About this manual

This is the Chinese operating manual (document MG34Q441, dated 04/2016) for the Danfoss VLT AutomationDrive FC 302 12-pulse frequency converter. It is organized into an introduction, safety instructions, installation, programming, general specifications and warnings/alarms, with a table of contents and an index.

The installation chapters cover pre-installation planning, lifting, mechanical dimensions, terminal positions for enclosure sizes F8–F15, cooling and airflow, panel options, and electrical installation including mains connection, grounding, fuses, shielding, motor cables and control terminals. The programming chapter describes the graphical LCP, initial commissioning and the parameter menu structure, while the specifications chapter lists mains supply, motor output, environmental conditions, cable sizes and control data. This manual is written in Chinese.

What's inside

  • Introduction
  • Safety Instructions
  • How to Install
  • Mechanical Installation
  • Electrical Installation
  • Connection Examples
  • How to Program
  • Quick Setup
  • General Specifications
  • Warnings and Alarms

Specifications

Maximum output frequency (from software version 6.72)Limited to 590 Hz
Leakage currentMore than 3.5 mA
CE certification range1400–2000 kW (1875–2680 hp), 690 V
UL complianceUL 508C temperature storage requirements
Dimension drawing unitsmm (in)
Minimum discharge wait time, 525–690 V (355–2000 kW)40 minutes

Frequently asked questions

变频器的输出频率最大限制是多少?

从软件版本 6.72 起,变频器的输出频率被限制在 590 Hz;软件版本 6x.xx 也将最大输出频率限制在 590 Hz。

切断电源后要等多久才能进行维护或修理作业?

按表 2.1,380–500 V(250–1000 kW)功率范围至少等待 30 分钟,525–690 V(355–2000 kW)至少等待 40 分钟。

谁可以安装和操作本变频器?

仅允许具备资质的人员安装和操作本设备,即经过培训且经授权按照相关法律法规安装、调试和维护设备的人员。

装有电子元件的变频器应如何处置?

不能同生活垃圾一起处理,必须按照地方和现行法规单独回收。

Download PDF (6.4 MB)

More Danfoss Manuals


View all Danfoss manuals →