Corsair Katar Pro Wireless gaming mouse setup guide covering 2.4 GHz and Bluetooth pairing, LED indicator states, power management and factory reset.
This bilingual Spanish/Portuguese setup guide introduces the Corsair Katar Pro Wireless gaming mouse and walks through getting it ready to use: removing the top cover, taking out the USB wireless receiver, inserting one AA battery, closing the battery cover and switching the mouse on. The left, right, middle, DPI, forward and back buttons, the multipurpose LED indicator, the optical gaming sensor, the PTFE glide pads and the power/wireless mode switch are all identified.
The guide explains how to set up the mouse over a 2.4 GHz wireless connection with the USB receiver or over Bluetooth, including the 12 to 15 second LED sequence that reports power state, battery state, wireless connection state and DPI stage. It also lists the LED colors for pairing and battery status, describes how to switch between gaming mode and power-saving mode without iCUE, and how to perform a factory reset. This manual is written in Spanish.
| DPI stages | Stage 1: 800 DPI, Stage 2: 1500 DPI, Stage 3: 3000 DPI |
|---|---|
| Battery | One (1) AA battery |
| Bluetooth requirement | Bluetooth 4.0 or later |
| Wireless modes | 2.4 GHz and Bluetooth |
| Glide pads | PTFE |
| Sensor | Optical gaming sensor |
Start Bluetooth pairing mode on a computer that supports Bluetooth 4.0 or later, then hold down the DPI cycle button while moving the power/wireless mode switch to the BT position. The LED blinks blue while pairing and stays blue when connected.
Turn the mouse off with the switch in the OFF position, hold the left and right click buttons at the same time, then turn the device on in either wireless mode.
The mouse takes one (1) AA battery, inserted after removing the top cover and the USB receiver.
Move the switch to the OFF position, hold the scroll wheel and move the power switch to 2.4 GHz or Bluetooth, then release the wheel. Repeat the steps to return to Gaming Mode.