Cisco HyperLocation 3600/3700 Access Point Module Quick Start Guide

Cisco quick start guide for deploying the Hyperlocation add-on module on Cisco 3600 and 3700 access points to compute Wi-Fi client locations.


Cisco HyperLocation 3600/3700 Access Point Module Quick Start Guide - cover page
Brand
Cisco
Category
Wireless connection
Document type
Quick Start Guide
Language
Chinese
Pages
12
File format
PDF
File size
2 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
201B2E6393F8B6630061FA608C792F4E

About this manual

This guide describes how to deploy the Cisco Hyperlocation add-on module and antenna on Cisco 3600 and Cisco 3700 wireless access points. According to the document, the module uses angle-of-arrival (AoA) information collected from a phased-array antenna to locate associated Wi-Fi clients more accurately and faster than traditional RSSI-based location solutions. Deployment requires a specific combination of Cisco wireless controller software, Cisco Prime Infrastructure for recording access point placement (X, Y, height and orientation), and Cisco Connected Mobile Experiences (CMX) 10.2.2, which computes client positions and makes them available through the CMX API or as input to CMX Analytics.

The guide lists eleven setup steps, from mounting the access points and connecting them to the wireless controller through importing maps, installing CMX, enabling Hyperlocation and running a static client accuracy test. It then covers assumptions and recommendations, including that every access point on a given floor must have the Hyperlocation module, that clients need a clear RF line of sight to at least three (preferably four) access points, that access points should be placed no higher than 20 ft and no more than 50 ft apart, that NAT between the wireless controller and CMX is not supported, and that only high-end vMSE hardware or a physical Cisco MSE 3365 is supported. Separate sections cover recommended software versions, physical deployment, wireless controller settings, Cisco Prime Infrastructure map placement and Cisco CMX configuration. This manual is written in Chinese.

What's inside

  • Installation and setup process summary
  • Assumptions and recommendations
  • Recommended software versions
  • Physical deployment
  • Wireless controller deployment
  • Cisco Prime Infrastructure deployment
  • Cisco CMX deployment

Specifications

Supported access pointsCisco 3600 and Cisco 3700 wireless access points
Spare module part numberAIR-RM3010L-x-K9=
Spare antenna part numberAIR-ANT-LOC-01=
Antenna frequency bands2.4 GHz and 5 GHz
Recommended access point mounting height10 ft
Access point height and spacing limitsNo higher than 20 ft, no more than 50 ft apart
Recommended Cisco WLC version8.1.131.20
Recommended Cisco Prime Infrastructure version3.1
Recommended Cisco CMX version10.2.2-340
Supported MSE hardwareHigh-end vMSE virtual appliance or physical Cisco MSE 3365

Frequently asked questions

How many access points must see a client for Hyperlocation to calculate its location?

The client needs a clear RF line of sight to at least 3 access points, preferably 4.

Which software versions are recommended for a Hyperlocation deployment?

Cisco WLC 8.1.131.20, Cisco Prime Infrastructure 3.1 and Cisco CMX 10.2.2-340.

Is NAT supported between the Cisco wireless controller and Cisco CMX?

No. NAT between the two is not supported; a non-NAT open connection is required for NMSP, location and SNMP packets.

Do all access points on a floor need the Hyperlocation module?

Yes, all access points on a specific floor must have the Hyperlocation module.

Download PDF (2 MB)

More Cisco Manuals


View all Cisco manuals →