Chrysler service bulletin 24-002-09 Rev. A covers 2007-2008 Grand Cherokee and Commander HVAC temperature control head replacement or ATC flash.
Chrysler Technical Service Bulletin 24-002-09 Rev. A applies to 2007-2008 Grand Cherokee (WH, WK, W2) and Commander (XK, XH) vehicles and addresses panel temperatures that increase too rapidly when the temperature knob is moved one or two detents from full cold in manual mode. It supersedes Technical Service Bulletin 24-002-09 dated May 6, 2009, and the revisions include a new part number for the ATC control head in Celsius.
The bulletin describes measuring center-duct outlet temperature at full cold and after moving the knob one detent at a time; if the differences are greater than 10 °F (5.5 °C), the repair procedure applies. MTC vehicles require replacement of the manual temperature control head and a manual door calibration. ATC vehicles require replacement of the ATC control if its software part number ends in 55111876ZA, followed by actuator calibration; otherwise the control is flashed using the wiTECH Diagnostic Application, with software release 10.01 or higher.
| ATC control part number (Fahrenheit) | 55111876AD |
|---|---|
| ATC control part number (Celsius) | 55111877AD |
| MTC control part number | 55037979AE |
| Temperature difference threshold | 10 °F (5.5 °C) |
| Required wiTECH software level | Release 10.01 or higher |
The customer may complain that panel temperatures increase too rapidly when the temperature knob is moved one or two detents from full cold while in manual mode.
With the vehicle at operating temperature, set panel mode, full cold and A/C on, turn the blower to High, and measure the center-duct outlet temperature with a thermometer. Move the temperature knob one detent toward hot and repeat for the next two detents.
The ATC control is replaced, and the Actuator Calibration function is initiated using the scan tool.
The wiTECH software level must be at release 10.01 or higher.