Chrysler Dart 2013 PF PCM Flash Engine Stability Service Bulletin

This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of Chrysler Group LLC. HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS AVAILABLE BY SELECTING “HELP” THEN “HELP CONTENTS” AT THE TOP OF THE wiTECH DIAGNOSTIC APPLICATION WINDOW. THE wiTECH SOFTWARE LEVEL MUST BE AT RELEASE 13.02 OR HIGHER TO PERFORM THIS PROCEDURE. SUBJECT: Flash: A/C and Drivability Improvements OVERVIEW: This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software. MODELS: 2013 PF Dart NOTE: This bulletin applies to vehicle equipped with a 1.4L engine (Sales Code EAF), the C635 manual transmission (Sales Code DE1), and 50 State Emissions (Sales Code NAS) built between May 3, 2012 (MDH 0503XX) and July 19, 2012 (MDH 0719XX). SYMPTOM/CONDITION: Customers may experience any or all of the following symptoms/conditions: • A noticeable reduction in A/C performance during hard accelerations. • 25 - 50 RPM engine instability at idle. • Hesitation in reverse at low speeds. • Performance derate at high altitude (greater than 6,000 feet) or in temperatures above 90°F. (32°C.). • A/C engagement Bump while accelerating at temperatures above 90°F. (32°C.). • Surge during accelerating. • Buck/bobble after sh


Chrysler Dart 2013 PF PCM Flash Engine Stability Service Bulletin - cover page
Brand
Chrysler
Category
Car
Document type
Service Manual
Language
English
Pages
3
File format
PDF
File size
114 KB
Published
03 November, 2023
Updated
03 November, 2023
MD5 checksum
DEC582BFAC496FEDBE1BD1CB56D7A533

About this manual

This Chrysler service bulletin 18-004-13, dated January 19, 2013 and grouped under Vehicle Performance, provides a procedure for selectively erasing and reprogramming the Powertrain Control Module (PCM) on 2013 PF Dart vehicles. It applies to vehicles with a 1.4L engine (Sales Code EAF), C635 manual transmission (Sales Code DE1), and 50 State Emissions (Sales Code NAS), built between May 3, 2012 and July 19, 2012.

The bulletin lists symptoms including reduced A/C performance during hard accelerations, 25 - 50 RPM engine instability at idle, hesitation in reverse at low speeds, high-altitude or high-temperature performance derate, A/C engagement bump, surge during acceleration, and buck/bobble after shifting. The repair procedure requires wiTECH release 13.02 or higher, battery charging voltage between 13.2 and 13.5 volts, PCM reprogramming, an ignition-off wait of at least 10 seconds, DTC P1302 handling, Cruise Control Learn, TLC Relearn, DTC clearing, and an Authorized Modification Label.

What's inside

  • Overview
  • Models
  • Symptom/Condition
  • Diagnosis
  • Parts Required
  • Repair Procedure
  • Policy
  • Time Allowance
  • Failure Code

Specifications

Engine1.4L (Sales Code EAF)
TransmissionC635 manual (Sales Code DE1)
Emissions50 State Emissions (Sales Code NAS)
Build date rangeMay 3, 2012 (MDH 0503XX) to July 19, 2012 (MDH 0719XX)
Required wiTECH softwareRelease 13.02 or higher
Battery charging voltage, minimum13.2 volts
Battery charging voltage, maximum13.5 volts

Frequently asked questions

Which engine and transmission must the vehicle have?

The bulletin applies to vehicles with a 1.4L engine (Sales Code EAF), C635 manual transmission (Sales Code DE1), and 50 State Emissions (Sales Code NAS).

What idle engine instability does the bulletin describe?

It describes 25 - 50 RPM engine instability at idle.

What wiTECH software release is required for this procedure?

The wiTECH software level must be release 13.02 or higher.

What should be done immediately after the PCM is flashed?

Turn the ignition key off for at least 10 seconds to allow the module to update and power down.

Download PDF (114 KB)

More Chrysler Manuals


View all Chrysler manuals →