Chinese user manual for the Bestway 58389 1500 gallon filter pump, covering safety warnings, base mounting, priming and operation, filter maintenance and…
This four-page Chinese user manual covers the Bestway 1500 gallon filter pump, model #58389. It starts with important safety instructions, including the maximum total head of 1.5 m, the requirement for a residual current device (RCD) with a rated operating current not exceeding 30 mA, and the rule that the pump must not be used while people are in the water.
The manual then explains how to bolt the pump vertically to a fixed wooden or concrete base, how to prime the pump through the air release valve (P6112) before starting it, and how to clean or replace the filter cartridge. It ends with freeze protection and storage instructions, a storage temperature range of 4–40 °C, and where to find warranty information at www.bestwaycorp.com. This manual is written in Chinese.
| Maximum total head (Hmax) | 1.5 m |
|---|---|
| Base mounting holes | 2 holes, 9 mm diameter, 160 mm apart |
| Minimum base weight | 18 kg |
| Storage temperature | 4–40 °C |
| Power supply protection | Isolation transformer or RCD with rated residual operating current not exceeding 30 mA |
| Standards listed | GB 4706.1-2005, GB 4706.66-2008, GB 4343.1-2018, GB 17625.1-2012 |
Open the air release valve (P6112) at the top of the pump; water flowing in pushes out the air. As soon as water comes out of the valve, tighten it and dry off any spilled water.
No. Before running the pump, make sure both the pool inlet and outlet are fully covered by water.
For hygiene reasons the manual recommends fitting a new filter cartridge every two weeks.
Unplug it, remove the hoses, dry all parts thoroughly and store the pump indoors, out of the reach of children, at 4–40 °C.