This is a troubleshooting guide for pool heaters, including error codes, reasons and solutions.
This troubleshooting guide for the Bestway Pool Heater lists the error codes E01 through E06, what causes each one, and the steps to resolve them. It covers water flow sensor issues, water temperature limits, sensor faults, manual reset and fuse problems, and states when to contact Bestway Swimming Pools instead of opening the heater.
A further troubleshooting section addresses problems such as a heating light that does not work, the heater not heating correctly, leaking inlet and outlet valves, and no water flow, with causes and solutions for each. General precautions include plugging the heater directly into the mains, avoiding direct sunlight for long periods, and never using the pool in winter or heavy rain.
| Minimum operating water/ambient temperature | 4°C |
|---|---|
| Maximum operating water/ambient temperature | 50°C |
| Water temperature before restarting after overheating | below 38°C |
| Water temperature before restarting after cold shutdown | above 6°C |
E01 indicates a water flow issue, such as a broken water flow sensor or a problem with water flow through the filter pump or sand filter.
E02 appears when the water or ambient temperature drops below 4°C. Unplug the heater, let it warm up in a warm environment, and put it back on the pool once the water is above 6°C.
Push the reset button on the pool heater. If the alarm is still visible, check the RESET BUTTON section of the manual or contact Bestway Swimming Pools.
Possible causes are loose hose clamps, a damaged or misplaced hose O-ring, or a broken hose between the filter pump and heater.