Analog Devices EVAL-ADM2867EEBZ ADM2867E Evaluation Board User Guide

User guide for the Analog Devices EVAL-ADM2867EEBZ evaluation board for the ADM2867E 5.7 kV rms isolated RS-485 transceiver.


Analog Devices EVAL-ADM2867EEBZ ADM2867E Evaluation Board User Guide - cover page
Brand
Analog Devices
Category
demo board
Document type
User Manual
Language
English
Pages
12
File format
PDF
File size
620 KB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
5C6BF2C1163E9117CA6B469A85882611

About this manual

The EVAL-ADM2867EEBZ is an evaluation board for the Analog Devices ADM2867E 5.7 kV rms isolated RS-485 transceiver. It provides screw terminals, test points, jumper options, and an on-board ADP7104 LDO regulator for 3.3 V or 5 V VCC operation, plus a flexible VIO supply from 1.7 V to 5.5 V.

The board includes an optional LTC6900 oscillator and an SMA connector for TxD input, supports loopback and ESD protection testing, and its 2-layer PCB meets EN 55032 Class B radiated emissions. The ADM2867E data sheet must be used with this user guide.

What's inside

  • Evaluation Board Hardware
  • Setting Up the Evaluation Board
  • Input and Output Connections
  • Radiated Emissions
  • EN 55032 Radiated Emissions Test Results
  • Full Duplex RS-485 Transceivers Loopback Test
  • IEC 61000-4-2 ESD Protection
  • Evaluation Board Schematic and Artwork
  • Bill of Materials

Specifications

Isolation voltage5.7 kV rms
Data rate25 Mbps
VIO supply voltage1.7 V to 5.5 V
ESD protection±12 kV contact discharge and ±15 kV air discharge
Optional oscillator frequency range1 kHz to 20 MHz
PCB construction2-layer PCB
Transceiver package10.15 mm × 10.05 mm, 28-lead SOIC_W_FP

Frequently asked questions

What equipment is needed to evaluate the board?

An oscilloscope, signal generator, 3.0 V to 5.5 V supply, and 1.62 V to 5.5 V supply are needed.

What document must be used with this user guide?

The ADM2867E data sheet must be used in conjunction with this user guide.

How is the ADM2867E powered directly from VREG_IN?

Insert the LK8 jumper into Position A.

Does the evaluation board meet radiated emissions requirements?

Yes, the 2-layer PCB meets EN 55032 Class B radiated emissions requirements.

Download PDF (620 KB)

More Analog Devices Manuals


View all Analog Devices manuals →