Analog Devices DC2470A LTC4284 High Power Negative Voltage Hot Swap Controller Demo Board Manual

Analog Devices DC2470A demo manual for the LTC4284 high power negative voltage hot swap controller in a 2.5kW, -48V application.


Analog Devices DC2470A LTC4284 High Power Negative Voltage Hot Swap Controller Demo Board Manual - cover page
Brand
Analog Devices
Category
demo board
Document type
User Manual
Language
English
Pages
4
File format
PDF
File size
403 KB
Published
16 November, 2026
Updated
16 November, 2026
MD5 checksum
990C277B02E60C4351E68255315CF954

About this manual

The Analog Devices DC2470A is a demonstration board for the LTC4284 high power negative voltage Hot Swap controller with I2C energy monitor and EEPROM in a 2.5kW, -48V application. It is configured for low stress staged start and includes isolation for power good control pins to enable downstream power converters. LEDs indicate the -48V input and output, the state of both supply feeds, and power good signaling.

The demo manual provides a quick start procedure, power good control details, digital interface and board layout information, power connection instructions, supply monitor inputs, board temperature measurement, jumper settings, and altered register values. Headers are provided for LTC evaluation interfaces with access to voltage, current, power measurements, fault logging, and board temperature.

What's inside

  • Description
  • Quick Start Procedure
  • Power Good Control
  • J1, J2 Digital Interface
  • Board Layout
  • Power Connections
  • Supply Monitor Inputs
  • Board Temperature
  • Jumpers
  • Altered Register Values

Specifications

Application power and voltage2.5 kW, -48 V
Power Good 1 delay256 ms after successful power-up
Power Good 2 delay after PG1256 ms later
Power good input timingwithin 512 ms after PG2 goes low
Power good output sink currentup to 1 mA
Plane isolation60 mil gap, 100 V DC standoff
Recommended power cable4 AWG (19 mm²) welding cable
Maximum mounting torque5 ft-lbs (6.8 Nm)
Default I2C address2Ah
EEPROM24LC025 (U4)

Frequently asked questions

What does the DC2470A demonstration circuit showcase?

It showcases the LTC4284 high power negative voltage Hot Swap controller with I2C energy monitor and EEPROM in a 2.5kW, -48V application.

When do the Power Good outputs go low?

PG1 goes low 256 ms after a successful power-up, and PG2 goes low 256 ms later.

What happens if PGI INPUT is not asserted within 512 ms after PG2 goes low?

The LTC4284 will shut down.

What cable is recommended for DC2470A power connections?

Use 4 AWG (19 mm²) welding cable for power supply and load connections.

Download PDF (403 KB)

More Analog Devices Manuals


View all Analog Devices manuals →