Guide to configuring RAID with the onboard FastBuild BIOS utility in UEFI setup, plus creating and deleting RAID arrays under Windows.
This AMD guide explains how to configure RAID functions by using the onboard FastBuild BIOS utility in the BIOS environment, and how to set up a RAID array with the UEFI Setup Utility before installing Windows. It notes that the BIOS screenshots are for reference only and may differ from the actual settings of a given motherboard, and that RAID support should be checked on the product specification page of the model in use.
The document first introduces RAID and the levels RAID 0, RAID 1, RAID 5 and RAID 10, then lists configuration precautions such as using identical drives of the same model and capacity and backing up data before creating a RAID set. The step-by-step sections cover enabling RAID mode, deleting existing arrays, creating an array through RAIDXpert2 Configuration Utility, and creating a new simple volume or deleting a RAID array under Windows.
| RAID 0 | Data striping that optimizes two identical hard disk drives to read and write data in parallel; does not provide fault tolerance |
|---|---|
| RAID 1 | Data mirroring that copies and maintains an identical image of data from one drive to a second drive |
| RAID 5 | Block striping with distributed parity across the physical drives |
| RAID 10 | Stripe mirroring: RAID 0 drives mirrored using RAID 1 techniques |
While the system is booting, press the [F2] or [Del] key to enter the UEFI setup utility.
Under Advanced \ Storage Configuration, set "SATA Controller(s)" to
Yes. Go to Boot \ CSM and set "CSM" to
Use two new SATA drives, and it is recommended to use two drives of the same size.