OptiPlex 5080 Micro Dust Filter Installation Guide
This guide from Dell explains how to install the dust filter on an OptiPlex 5080 Micro system. It states that the dust filter helps protect the system from fine dust particles. The document walks through preparing the system before installation, including shutting down, disconnecting cables and peripherals, and handling a monitor-mounted unit.
The installation steps describe aligning the top edge of the dust filter with the top edge of the system and pressing the lower edge until the filter fits snugly. The guide then shows how to set a pre-boot reminder in the BIOS under System Configuration > Dust Filter Maintenance, with intervals of 15, 30, 60, 90, 120, 150, or 180 days, and how to clean the filter. It closes with steps to reconnect the system and with Dell contact information.
| Dust filter maintenance reminder intervals | 15, 30, 60, 90, 120, 150, or 180 days |
|---|---|
| Dust filter maintenance default setting | Disabled |
| BIOS location for dust filter settings | System Configuration > Dust Filter Maintenance |
| Key to enter BIOS Setup menu | F2 at the Dell splash screen |
| Document revision | Rev. A00, November 2020 |
Align the top edge of the dust filter with the top edge of the system, then press the lower edge of the filter to close over the system and gently press down so it fits snugly.
Restart the system, press F2 at the Dell splash screen, then go to System Configuration > Dust Filter Maintenance and pick an interval. The default setting is Disabled.
Brush or gently vacuum the filter, then wipe down the external surfaces with a moist cloth.
Alerts are generated only during a system reboot and not during normal operating system operation.