This document describes the deployment of FCoE (FIP Snooping) on Dell PowerConnect 10G switches.
This document provides detailed instructions for configuring FCoE (FIP Snooping) on Dell PowerConnect 10G switches, specifically the M8024-k, 8024, and 8024F models. It covers deployment scenarios with Cisco switches, including NPIV and NPV modes, and explains how to disable Simple Mode and update firmware. The guide includes CLI commands and configuration examples for validating and troubleshooting setups.
The document assumes the switches are running firmware 4.2 or later and are not in Simple Mode. It also notes that stacking is not recommended in FCoE environments and that non-FIP-aware switches will break FCoE functionality. Configuration steps are presented sequentially but are often executed in parallel in practice.
Firmware version 4.2 or later is required for FCoE support. The document states: 'Starting with firmware 4.2, the latest PowerConnect™ 10 Gigabit switches can now be used as an FCoE Transit Switch (FIP Snooping Bridge, T11, BB-5).'
No, FCoE is not supported with the PowerConnect 8024 model switches in Simple Mode. The document states: 'FCoE is not supported with the PowerConnect 8024 model switches in Simple Mode.'
No, stacking is not recommended in an FCoE environment with the Dell PowerConnect 8024 Model Switches. The document states: 'Stacking is not recommended in an FCoE environment with the Dell PowerConnect 8024 Model Switches.'