Dell Instant Networking W-IAP103 Wireless Access Point Installation Guide

The Dell Instant Networking Access Point W-IAP103 Installation Guide provides information on how to install and configure the Dell Instant Networking Access Point W-IAP103.


Dell Instant Networking W-IAP103 Wireless Access Point Installation Guide - cover page
Brand
DELL
Category
Other network devices
Document type
Installation Guide
Language
Portuguese
Pages
2
File format
PDF
File size
534 KB
Published
25 November, 2023
Updated
25 November, 2023
MD5 checksum
3EC0E903ACF8CB03D3394BE4D76F03B2

About this manual

This document is the Portuguese-language installation guide for the Dell Instant Networking W-IAP103 Instant access point. The W-IAP103 supports the IEEE 802.11n standard for WLAN at 2.4 GHz or 5 GHz with simultaneous support for existing 802.11a/b/g wireless services, uses MIMO technology, and works only together with a virtual controller. It can operate as a wireless access point or as a wireless air monitor under IEEE 802.11a/b/g/n, and is compatible with PoE IEEE 802.3af.

The guide lists the package contents, describes the hardware (four status LEDs, 4-pin console port, 10/100/1000Base-T Ethernet port, DC power jack, Kensington lock and reset button), explains the pre-installation checklist and site selection, and gives step-by-step instructions for mounting the access point on a ceiling rail using the included 9/16" and 15/16" rail adapters. It also includes an LED behavior table, the Gigabit Ethernet RJ-45 pinout, and FCC and EU regulatory notices. This manual is written in Portuguese.

What's inside

  • Package contents (Conteúdo da embalagem)
  • Hardware overview of the W-IAP103 AP
  • LEDs and LED behavior table
  • Console port
  • Ethernet port and RJ-45 pinout
  • DC power jack
  • Reset button
  • Pre-installation checklist (Antes de começar)
  • Installing the IAP with the ceiling rail adapter

Specifications

Wireless standardIEEE 802.11a/b/g/n
Operating bands2.4 GHz or 5 GHz
Ethernet port10/100/1000Base-T (RJ-45), auto-sensing, MDI/MDX
PoE supportIEEE 802.3af, 48 V DC nominal (as a PD)
DC power input12 V DC (+/- 5%) / 18 W
DC plug1.7/4 mm center-positive circular plug, 9.5 mm length
Console port4-pin connector with dust cover
Required softwareDell Instant 4.1 or later

Frequently asked questions

How do I reset the W-IAP103 to factory settings?

Power off the IAP, press the Reset button with a small narrow object such as a paper clip, power it on while holding the button, and release it when the power LED blinks again after 15 seconds.

How is the W-IAP103 powered?

It can be powered via PoE IEEE 802.3af (48 V DC nominal) or, when PoE is unavailable, with a Dell AC/DC adapter kit or any local DC source meeting the 12 V DC (+/- 5%)/18 W specification.

Can the W-IAP103 be mounted on a ceiling rail?

Yes, it ships with 9/16" and 15/16" ceiling rail adapters; the access point is attached at about a 30-degree angle to the adapter and rail and twisted clockwise until it locks in place.

Does the W-IAP103 work without a controller?

No, the W-IAP103 Instant access point works only together with a virtual controller, which is configured as the fourth step of the setup process.

Download PDF (534 KB)

More DELL Manuals


View all DELL manuals →