This document describes the installation instructions for Dell UPS power supplies.
This two-page Dell document gives the instructions for installing an optional power cord on selected Dell UPS models. It opens with a warning that electrical installation must be carried out only by qualified service personnel such as a licensed electrician, that utility power must be switched off at the distribution point where the UPS will be connected, and that the UPS user's manual should be consulted for more information. The same warning and notes are repeated in several languages.
The second part lists which power cord goes with which UPS model: MRVDY for 4200W 208 Vac UPS, 913CC for 3750W, 4200W or 5600W 230 Vac UPS, and 6WWDY for 4200W or 5600W 230 Vac UPS, with a note that the cord is not for use with the 5600W Online UPS. A table then gives the terminal positions (G for input ground, N for L2/Neutral in, L for L1/Line in), the wire size rating of 5.26–16 mm2 (10–6 AWG) and a tightening torque of 2.26 Nm (20 lb in), followed by the copyright and trademark notice dated October 2011.
| Wire size rating | 5.26–16 mm2 (10–6 AWG) |
|---|---|
| Terminal tightening torque | 2.26 Nm (20 lb in) |
| Terminal positions | G = input ground, N = L2/Neutral in, L = L1/Line in |
| Power cord for MRVDY | 4200W, 208 Vac UPS |
| Power cord for 913CC | 3750W, 4200W, or 5600W, 230 Vac UPS |
| Power cord for 6WWDY | 4200W or 5600W, 230 Vac UPS |
MRVDY on the 4200W 208 Vac UPS, 913CC on the 3750W, 4200W or 5600W 230 Vac UPS, and 6WWDY on the 4200W or 5600W 230 Vac UPS.
The terminal wire size rating is 5.26–16 mm2 (10–6 AWG).
The tightening torque is 2.26 Nm (20 lb in).
No, the document states the cord is not for use with the 5600W Online UPS.