Dell PowerEdge M1000e, M915, M910, M820, M710HD, M710, M620, M610x, M610, M520, and M420 Getting Started Guide
This Dell PowerEdge Getting Started Guide covers the M1000e enclosure and the M915, M910, M820, M710HD, M710, M620, M610x, M610, M520 and M420 blade servers. It describes unpacking the system, installing the rails and enclosure in a rack, and installing quarter-height, half-height and full-height blade servers.
The guide also explains connecting the CMC and optional iKVM modules, connecting AC or DC power supplies, turning on the enclosure and blade servers, and completing the operating system setup. It ends with technical specifications for blade server and enclosure power supplies, including voltage requirements and heat dissipation. This manual is written in Portuguese.
| Blade server coin-cell battery | 3 V CR2032 lithium coin cell |
|---|---|
| AC/DC power supply output (2,360 W and 2,700 W models) | 2,360 W and 2,700 W |
| AC/DC power supply connector (2,360 W and 2,700 W models) | IEC C20 |
| AC/DC power supply output (3,000 W model) | 3000 W |
| DC/DC power supply output | 2700 W |
| System voltage requirement (2,360 W and 3,000 W power supplies) | 16 A, 200 VAC to 240 VAC, 50/60 Hz |
| System voltage requirement (2,700 W power supply) | 16 A, 100 VAC to 240 VAC, 50/60 Hz |
| Maximum heat dissipation (2,360 W and 2,700 W AC/DC power supplies) | 1205 BTU/h |
A minimum of three power supplies is required.
No. DC and AC power supplies cannot be mixed in an enclosure.
The procedure applies only to the PowerEdge M420.
The top slot of the enclosure (Blade a) must be empty.